Brilliant. My chain jumped out of the sprockets, and I didn't know how to fix it. I also didn't know that when you take off the guard, you can just pop the chain out and re-connect it. I do now! 0:24 seconds into the video - and I had the job fixed and my awesome little log cutter working fine again! 🪚😃
My friend, those wood chips were put there for a video. No way that saw was that clean! One minute of actual use would have put enough "gunk" on the saw to render is looking "used". I have one of these and keeping that chain tight is super frustrating!
If you replace it with a genuine Stihl chain, you can expect well over 500 2" cuts through unseasoned wood. No chain adjustment required. But do keep it oiled and clean after use. Supplied with a totally inadequate amount of chain oil. You will need to buy more!
Would you say oil it each time you have to charge the battery? Oil both sides all the way round? Or a few spots on the visible part then spin it for a few seconds? It's great to have exact information.
I have just used it with olive trees in Greece.....i was very dissapointed to realize that the chain goes off as you work quite often and the saw stops!!! You have to take the battery off, put the teeth of the chain back at their place and then again battery on and start again!!!it happened 3 times untill the battery was down.I have tried to turn the chain 2 rounds as per the instructions,but it kept doing it....also,all the time leaves and small branches get in the chain....as you work.....and finally,if you force it to a big piece of tree,it stops!for the money i bought it,although it is light and easy for women,it is not worth it...
Good question. Notice the video shows how much slack there should me to the millimeter but fails to mention that you couldn't do anything about it it it were off. However, I found a way to adjust the tension: Take a small piece of steel bailing wire, pound one end flat, push the piece into the area forward of what should be the tensioner, clip the end and tap the wedge into place. Its been working well now to extend the life of a chain that is still good but just stretched that little bit.
You can tighten the chain. You use the wing nut. Crack it loose pull outward on the tip of the bar and chain and hold while you tighten the wing nut back up. Just watch your fingers don't slip
Cleaning must also be done on the engine. It has to be blown with a motorized compressor, otherwise you will suffer what I suffered. The engine got dirty and the engine stalled and did not work until the engine was cleaned.
Uma porcaria, não gastem vossos dinheiro com essa máquina. Tudo que vi como podam galhos só quando está no primeiro uso. Depois corrente fica deixa, uma loucura para tensionar. Já no segundo uso
Excellent video! Thank you
Can you please do video of how to replace a
new break handle on electric MSA 200c
Brilliant thank you. Love my little chainsaw.
Brilliant. My chain jumped out of the sprockets, and I didn't know how to fix it. I also didn't know that when you take off the guard, you can just pop the chain out and re-connect it. I do now! 0:24 seconds into the video - and I had the job fixed and my awesome little log cutter working fine again! 🪚😃
My friend, those wood chips were put there for a video. No way that saw was that clean! One minute of actual use would have put enough "gunk" on the saw to render is looking "used". I have one of these and keeping that chain tight is super frustrating!
how do you tighten it when its too loose?
If you replace it with a genuine Stihl chain, you can expect well over 500 2" cuts through unseasoned wood. No chain adjustment required. But do keep it oiled and clean after use. Supplied with a totally inadequate amount of chain oil. You will need to buy more!
Greatest how to vid ever.
This song is a banger! Excellent video, also!
Great video ! No fluff👍
thanks! i NEEDED video!
Not a very good design, there's no chain adjustment, after 20 cuts you might as well throw the chain away.
You tighten the chain by pulling the bar out as you tighten the lock screw. He does this in the video 😊
My bar only moves forward like a mm.
Does Stihl recommend a particular file to sharpen the GTA 26 chain?
I just use a reg 1/8" Stihl round file.
No adjustment?? My opinion on Stihl has just dropped a great deal. I guess I’ll have to order some replacement chains.
My chain keeps coming out. I tried to fix it but it's not working.
Whst was the issue?
Very good thanks
How frequently should you oil the chain. Neither the instruction manual or this video cover this important point!
It's in the manual actually. It says before each time you use it. Just a few drops is all you need. Remove battery first.
Would you say oil it each time you have to charge the battery? Oil both sides all the way round? Or a few spots on the visible part then spin it for a few seconds? It's great to have exact information.
I have just used it with olive trees in Greece.....i was very dissapointed to realize that the chain goes off as you work quite often and the saw stops!!! You have to take the battery off, put the teeth of the chain back at their place and then again battery on and start again!!!it happened 3 times untill the battery was down.I have tried to turn the chain 2 rounds as per the instructions,but it kept doing it....also,all the time leaves and small branches get in the chain....as you work.....and finally,if you force it to a big piece of tree,it stops!for the money i bought it,although it is light and easy for women,it is not worth it...
How do you tighten the tension of the chain if it’s loose?
Poor design, there is no chain adjustment, you have to throw the chain away and get a new one
@@jaimealvarez912 my thoughts exactly. would have been a perfect tool if it did.
Good question. Notice the video shows how much slack there should me to the millimeter but fails to mention that you couldn't do anything about it it it were off. However, I found a way to adjust the tension: Take a small piece of steel bailing wire, pound one end flat, push the piece into the area forward of what should be the tensioner, clip the end and tap the wedge into place. Its been working well now to extend the life of a chain that is still good but just stretched that little bit.
You can tighten the chain. You use the wing nut. Crack it loose pull outward on the tip of the bar and chain and hold while you tighten the wing nut back up. Just watch your fingers don't slip
How to tighten chain on Stihl GTA26 chainsaw
You can't, they say you can, but you can't
Mine stopped 3 times because the chain got off...... And you cant tighten it..... Big dissapointment!!!!
Pull the bar out before you tighten.
Cleaning must also be done on the engine.
It has to be blown with a motorized compressor, otherwise you will suffer what I suffered.
The engine got dirty and the engine stalled and did not work until the engine was cleaned.
Can't get guide bar off
Chain is off track
Dissapointing for such a good brand. No way to adjust chain. Cut a few times, and it jams. Waste of money.
Sorry to hear that. We have had almost unanimously positive feedback. Can I suggest getting it checked at a STIHL Dealer?
@@STIHLNewZealand After a few uses, the chain loosens and there is no way to tighten it? What a disappointment, I feel deceived
Uma porcaria, não gastem vossos dinheiro com essa máquina. Tudo que vi como podam galhos só quando está no primeiro uso. Depois corrente fica deixa, uma loucura para tensionar. Já no segundo uso
Is he a office worker, gloves, afraid of a wee bit dirt or oil or a nip of the chain. Modern men turning soft. Yuk.
Just more product placement with the gloves.