How to correctly connect a stepper motor driver with any plc?||Complete Guide

Here we have another simulation
• CONTROL BOMBA DE AGUA ...
Good, today I will teach you how to connect the stepper motor with a plc and test its operation
Subscribe to the channel for more videos like these below .....
↓
Control of Alternating Pumps and Constant Pressure with plc LOGO! 8
• Programar PLC LOGO EN ...
SCADA SYSTEM WITH LABVIEW: Modbus ServoDrive controlled with plc s7 200
• ¿Cómo monitorear y con...
Simulation in Solidworks and LabVIEW with plc s7200 of Servomotors
• Controlar servomotor o...
Frugos bottle filling process and simulation in Labview
• Proceso y Simulación d...
and more
/ @indeesac
MUSIC
Hope
Tobu
/ tobuofficial

[@user-oe5uv4hh3j]

Please tell me how to program؟

[@JoseMendez-uk9bu]

What do I do If my Drive Does not have a + and - DIR and PUL, It only say PUL, DIR, OPTO and ENA is a DM322E microstep driver. Also can you Connect two drivers to a single PLC? My PLC has a [3L+ 3M .0 .1 .2 .3]

[@IndeeSac]

Hi Jose, regarding your type of driver, in these cases they are usually negative pulse, that is, your plc must output NPN, in the OPTO you place +24V, and in PUL and DIR with resistance to the respective pulse outputs.
With respect to your plc according to its model, see if it comes out NPN or PNP at its output.

[@erickouadio4708]

Bonjour . Recevez mes encouragements pour vos efforts. Cependant il serait très intéressant de traduire vos vidéos en français. Merci

[@IndeeSac]

Bonjour, merci pour le commentaire, je viens d'ajouter des sous-titres français, j'espère que c'est très utile, bonne journée.

[@erickouadio4708]

@@IndeeSac merci à vous

[@gustavoabarzuavega3539]

can i connect a second stepper motor to the same motor driver ? or i need another motor driver?
I want both motors to have the same movement at the same time
Thanks

[@IndeeSac]

Hi, different controllers are needed, and for the pulses too, you can program it in the same pulse output, in this case a plc, that does the same function at the same time

[@burkankoc1566]

are the resistors necessary? and what happends if i don't use resistors?

[@IndeeSac]

Hi, yes it is necessary because the output of the plc transistor gives you 24 volts and the controller needs 10 or 5 volts, if you do not place it you can damage your driver.

[@fdfd9338]

@@IndeeSac hi. Q out of 224x gives "+" or "-" 24v ?

[@IndeeSac]

@@fdfd9338 CPU224 is positive pulse, new models CPU 224 Y CPU286 is negative pulse

[@IndeeSac]

IF IT IS ANOTHER PLC, LOOK FOR ITS DIAGRAM, TO KNOW IF IT IS POSITIVE OR NEGATIVE

[@alvixtan1617]

@@IndeeSac Why is it 2.2k Ohm? How to calculate it?