Harman Kardon Citation 25 Preamplifier & Citation 22 Amplifier (Demo 1) (Room Sound • Omni Mics)

HARMAN KARDON CITATION 22 AMPLIFIER
Specifications:
• Power output: 200 watts per channel into 8Ω (stereo)
• Frequency response: 20Hz to 20kHz
• Total harmonic distortion: 0.08%
• Damping factor: 120
• Input Sensitivity/Impedance: 1.0V/22K Ohms
• Signal-to-Noise Ratio: 100dB
• Dimensions: 17 3/8" x 6 1/8" x 15 11/16" in
• Weight: 45 lbs
____________
HARMAN KARDON CITATION 25 PREAMPLIFIER
Specifications:
• Frequency response: 20Hz to 20kHz
• Total harmonic distortion: 0.005%
• Input sensitivity: 0.125mV (MC), 2.2mV (MM), 130mV (line)
• Signal to noise ratio: 73dB (MC), 78dB (MM), 84dB (line)
• Channel separation: 55dB (MM), 54dB (MC), 54dB (line)
• Dimensions: 17 3/8" x 3 3/8" x 14 5/8" in
• Weight: 20 lbs
____________
RECORDING
• Artist: George Benson & Earl Klugh
• Album: Collaboration
• Title: Mt. Airy Road
• Year: 1987
• Label: Warner Bros.
______________
SOURCE
• Koetsu Urushi Vermilion
www.koetsuaudio.com/urushiverm...
• VPI Avenger Reference Turntable
www.vpiindustries.com/avenger...
• ModWright PH 9.0 Phono Stage
www.modwright.com/sources/ph-9...
* All three products above are available for purchase exclusively from Let There Be Sound, L.L.C. of Weston, Florida. For more information contact Oswaldo Martinez at:
e-mail: [e-mail]
mobile: [phone]
______________
Digital Recorder
• Tascam DR-100 MkIII Portable Digital Recorder @ 24-bit/192k Resolution
(Room Recording using Tascam's built-in OMNI MICS)
______________
Produced by
Oswaldo Martinez
President
Let There Be Sound, L.L.C.
mobile:[phone]
e-mail: [e-mail]
www.lettherebesound.com

[@estebanflores7226]

Buena música y equipo fantástico.

[@LetThereBeSound1]

Gracias!

[@insolentstickleback3266]

They are beautiful, what speakers are we listening to?

[@LetThereBeSound1]

Thank you! They are the System Audio Legend 60 loudspeakers from Denmark.

[@user-ni1nt7ps9u]

Hi when Citation 22 goes in High voltage mode , red led diode ?

[@snoofusleejones]

Yes, the amplifier has switches in the back to activate’High voltage’ mode for 8 ohm loads. This increases the voltage present on the voltage rails, allowing for more watts delivered into 8 ohm loads. The red LED in front will turn on to confirm this selection.

[@user-ni1nt7ps9u]

@@snoofusleejones hi , there is also one button in front panel for 4 and 8 Ohms . Which actually changes the state of the load, who is a main one and why there are two switches, one from the front and one from the back ? I have this power amplifier, and 2 pairs of speakers, one at 8 and the other at 6 ohms.