GM HOLDEN 308 V8 Build Part 1 (Pistons and Main caps)
ฝัง
- เผยแพร่เมื่อ 30 เม.ย. 2020
- Part 1 of 4 Mick from 'MS Engine Reconditioning' building my 308 Holden V8 motor.
If you would like to follow us on facebook see below!
/ msenginereconditioners - ยานยนต์และพาหนะ
Thanks for the uploads 👍
Though it would be good if the camera man filmed in landscape not portrait mode
Love your videos Mick
The accumulator groove provides additional volume below the top ring so pressure doesn’t build up and attempt to unseat the top ring.
YA BANG ON MATE WITH THE CONRODS BOLTS . .
Good bloke👍
nice engine malaka
do you drill out the block inside the oil pump mount to allow greater oil flow through the block ??
You forgot to check the thrust clearance on the crank it's always nice to know that it is within tolerance.
Hey Mick do you know the build codes for those blocks by any chance?
Great video but please do a wide video instead.. it's too small to see anything
Old tech
Pushrod engines are so good
@@markm4603 like steam engines
Yes, for an old car. Fool.
@@Hardtarget87jcvd shit technology
Filmed with a potato