How To Replace Rear Wheel Hub 2007-16 GMC Acadia

Buy Now!
New Wheel Bearing & Hub Assembly from 1AAuto.com trq.video/ib-1...
New Wheel Bearing & Hub Assembly Set from 1AAuto.com trq.video/ic-1...
New Wheel Bearing & Hub Assembly Set from 1AAuto.com trq.video/ic-1...
Not only can a worn wheel bearing or hub be annoying if it is noisy or vibrating, but it can also lead to accelerated wear in other parts, or unsafe driving conditions. Replacing your worn bearing or hub with a quality TRQ part is a safe, smart, decision. This video shows you how to do the replacement yourself on your 2007-2016 GMC Acadia.
• Check here for more videos on the 2007-16 GMC Acadia: • GMC Acadia 2007-16 1st...
This repair was done on a 2012 GMC Acadia Denali 3.6L and the process should be similar on the following vehicles:
2007 GMC Acadia
2008 GMC Acadia
2009 GMC Acadia
2010 GMC Acadia
2011 GMC Acadia
2012 GMC Acadia
2013 GMC Acadia
2014 GMC Acadia
2015 GMC Acadia
2016 GMC Acadia
Tools you will need:
• Pry Bar trq.video/oyg-...
• 10mm Socket trq.video/oajd...
• 18mm Socket
• 21mm Socket
• 22mm Socket trq.video/ogU-...
• 34mm Socket trq.video/oK-1...
• Brake Caliper Hanger trq.video/oeN-...
• Slide Hammer
• Needle Nose Locking Pliers
• Ratchet trq.video/oaEu...
• Torque Wrench trq.video/oYP-...
• Copper Anti-Seize
• Gloves trq.video/onV-...
• Rust Penetrant
• Safety Glasses
• Center Punch trq.video/ogV-...
• Floor Jack trq.video/oDo-...
• Hammer
• Wheel Chocks
• Wire Brush trq.video/oke-...
Subscribe: / @trq
Check out our playlist:
GMC Acadia 2007-16 1st Generation: • GMC Acadia 2007-16 1st...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ *Watch the Video*
√ *Buy The Part at 1A Auto* 1aau.to/m/Shop-TRQ-Parts
√ *Do it Yourself*
√ *Save Money*

[@chrislanacelauro6384]

Videos from TRQ have always been detailed , easy to follow and very well made . They go slow and show each step ! Very useful . Thank you TRQ. Keep up the good work ! 👍

[@TRQ]

+@chrislanacelauro6384 Thanks for watching our video! 1aau.to/m/Shop-TRQ

[@Toolie716]

Whats the tool you used to remove the springs

[@10947792]

Great video tutorial. Excellent editing. Good instructor techniques. Succinct and to the point.

[@lancemarchand2639]

Great video and it helped a ton. Watched your other one on the seized hub removal and that was a big help too! Ended up cutting 2 wheel studs off and pounding them out and then using two bolts nuts and washers to force the hub out. Everything went fairly ok but watching all these videos nothing came as a surprise as I hit one snag after another. Stupid parking brake shoe lining fell off as I was putting the shoes back on so add another $50 to my repair bill. Thanks again.

[@CHB_98]

does the fwd have the same set up in the rear ?

[@marcboudreault6717]

Great video, to the point with all the details! Thx so much!

[@leowiebe2101]

I really appreciate you guys Very helpful especially on a limited budget.

[@BxNyLife]

If my driver side bearing is bad will the steering wheel causes to pull left? Cause I am dealing with left pull in 5-25mph driving slow steering wheel turns decently fast to the left and at highway speed it pull as well to the left, I’ve done numerous wheel alignment, balancing. I even replace sway and steering linkage no sign of improvement and tires are new also did 4 tires cross swapped nothing. Any suggestions? Thanks!

[@josepharagon8259]

I think you’re on the right track. These AWD’s are hard to feel any drag on those bearing’s. Rust on the speed sensor is a good reason to suspect that water has gotten into the bearing

[@suchprofessor5636]

I learned to drop the knuckle forward and hammer it out from the back. Just take out 2 extra bolts and save yourself a lot of time

[@thewarehouseguy9440]

Second this, worked great beating it from the back

[@marshalllove]

@@thewarehouseguy9440 That's what she said

[@ivenothumbs]

Does this include a all-wheel drive model

[@Hogbellylife]

Thanks for the video!

[@codyscar]

am i seeing this right that the rear has pads and shoes?

[@Rbrbrb56]

Made that look way too easy. He didn’t even swear and start kicking it.

[@blendedfamilyfun-tv9221]

Serjous question, on a 2wd 09 acadia does it still have the axle and 34mm nut and rubber boot part connected to the back of the hub? Cause I took mine apart and it doesn't have that on either side on the rear. Seems like I'm missing parts wondering if the guy I bought it from screwed me big time..

[@anthonystone266]

Nope 34mm is the cv axle. No axle in the rear

[@Jacksonransom]

This channel is very similar to 1aauto.......

[@dbk6149]

The Denali is no different right?

[@TRQ]

+DBK 614 The installation for the Denali model should be the same.

[@josepharagon8259]

The Denali is so much easier…(front)

[@Ben-xm6li]

Awesome video, thanks

[@ItsSlim911]

Abs sensor doesn't need removal.. just broke a $60 sensor for nothing. 2013 Denali

[@lambo7403]

Solid Video!!

[@robertharrington3395]

Control arm right side

[@maxmorrison9428]

Anyone else just trying to replace the lug studs, lol