Range Rover misfire. Part 1. Diagnosis.
ฝัง
- เผยแพร่เมื่อ 29 ส.ค. 2024
- Be part of this channel! = britrest.com/s...
Shop 'till you drop = www.britrest.c...
www.gettr.com/...
utreon.com/c/b...
www.paypal.me/...
/ britrest
Your support is appreciated!
If you have a Defender/Tdi problem and do not know how to fix it, drop me a line!
Maybe I can help!?
britrest@britrest.com
Send me a postcard for my wall!
Britannica Restorations Ltd
9 Ch. Rawson
Sherbrooke
Quebec
J1M2A3
Canada
Doing both head gaskets on my 5.0 V8 HSE right now. I have a whole host of other issues, but I did soak the injectors in a cup of BG 444 for a couple hours, then used a super fine dental pick and a magnifying glass (to see fine detail) to clean out the nozzle holes and soaked them for another hour. They look brand new now.
Thanks for sharing
Bravo Mr Marconi , I bet all the TV viewers in greater Sherbroke will love you when you fire that spark transmitter up! Bosh made a combined sandblaster and tester for two stroke spark-plugs back in the 1950s
You're doing all the right stuff to track down and isolate the problem Mike, I'm sure you'll have it back running on 8 cylinders very soon.
I wish you were by me here in Wisconsin. I've got a v8 d2 started random misfiring on me 2 years ago. Replaced the wires, plugs, coil packs, couple cheap sensors forget which ones because it was two years ago and internet suggested it with no luck. Now 2 years later in trying to tackle it again...😂 what a headache
Hey have you tried the injectors? I had a misfire and did the coils and everything and it fixed it for about 9 months now there is a random cylinder 5 misfire and it smells like fuel but the spark plug is working great and receiving power while testing still connected to the plug wire. Just curious if you solved years before I take my manifold off and get injectors
I have seen people clean injectors by spraying carb cleaning up the rear and then powering them from a battery on a bench.
Of course if you have somewhere than can clean and test them. Finding the 8 with the closest flow rate to each other for a nice balanced set will be the best result.
See next video for testing!
@@BritannicaRestorations why bloody part 2 is missing??
I remember as a teenager trying to test the plug on a two stroke mower with old hold the plug against the head and turn the engine over. Thankfully I was out of the way of the flame that shot about two meters across the garden?
lol!
Was expecting Frankenstein to rise from the bench⚡️⚡️⚡️ 😆
Lol!
What a bugger about this job is ! I have zero experience with this inlet system. Excellent video Mike I like both them spark plug testers
Strange one to diagnose as there are 2 electric components - plugs and injectors - have to check both
Well done Michael.
It would be helpful to people doing searches if you put the model in the title along with "Range Rover"
That’s a cool little tool I want one only trouble my teeth are starting to hurt sounds like being at the dentist 🦷
Hi Mike, when I had misfire issue with my Discovery 2 V8 it was the plug leads replace the original replace them with good after market ones, also had to ensure the ht leads are pushed into the ignition coils.
All leads are firing to the plugs, and all plugs are firing correctly according to the machine
See next thrilling instalment!
Had loads of intermittent misfire issues with my 4.2 v8 defender over the years. As it was dual fuel and only happened on petrol I knew it was injector issue. I read they were notorious for sticking so tried cleaner and putting a small amount of 2 stroke oil in fuel. Seemed to help a little.
But eventually I found corrosion on injector plug. Which I think was the main issue.
I remember garages in the 70's with electrical test equipment. A Sun or AC rolling bench for testing generators, batteries or ??
Hey mike ,Might explain the fuel in the oil you had early on from memory. Nice find though mate 👍
Could be
Many years ago, I was testing the ignition harness on a 7 cylinder radial aircraft engine. The harness was laying on the floor and I was sitting on the floor as well. I did not realize I was sitting on one of the spark plug leads, until I got a 25,000 volt attention getter in the RT cheek! One of the guys I was working with, said I came about 2 ft off the floor! 😳
You would be correct to ASSume I never did that again.😬
Nice one! Lol!
Had a misfire on a car once, got the injectors cleaned but still not right. Ended up replacing an injector and it went away. We blamed supermarket fuel and bought from other places after that. Tbf, couldn't be certain that's what caused it but didn't have an issue afterwards. Pleased that my V8 is relatively straightforward with an Edelbrock sitting on top.
See the next thrilling instalment!
@@BritannicaRestorations Looking forward to it.
Switch out injectors 5 and 6 and also 7 and 8. If it's the injectors the problem will move.
Could do, but a lot of faffing about - see next video!
@@BritannicaRestorations Dead easy from my armchair. :)
lol!
Mike, where are you sending your injectors in Canada for cleaning? I have some that need a clean, but can only find US testers/cleaners
Well, I could not find anything local, so I did them myself - next video
But I could not balance them - but to be honest, this is not an F1 car - but it sounded pretty good in the end!
My 4.0 Disco2 has had new coil pack plugs and wires last year but started a cylinder 5 misfire today. I pulled that plug and left it connected to the wire and it has a very good spark. There's no vacuum leaks and spark plug was pretty dry but still good condition. I think maybe it is a bad injector and in addition the O-rings because I can smell fuel while driving what's the misfire started happening. Does that sound right? I haven't taken it apart yet
Could be a bad plug? The knock sensor on the side of the engine detects misfires not the coil pack
THATS NOT A DIE'ZELL - LEAVE THAT UP TO THE YANKS ! - THE "MRS" IF YOU CAN SAY THAT IN TRUDEAU CANADA ISN'T HAPPEN