That looks pretty dang good David! Bead rollers are a pain. The trunk floor is most of the way out, and I’m hoping to get the rest cut out later today.
Looking good, looks like a bit of rework will get you there. I’ve found the handle of my engine crane is handy for bending smaller radius curves around!
Good start. Looks good. The trough on the new part looks a little too narrow as compared to the original. Granted no one will see it under normal circumstances, but you'll find fitting it easier the closer to original profile you can get.
@@drivewayshop it's tough to tell, but it does match the contour gage pretty closely. When I cut out the old section it'll be much easier to know how close it is.
That looks pretty dang good David! Bead rollers are a pain.
The trunk floor is most of the way out, and I’m hoping to get the rest cut out later today.
Yes the bead roller was literally a pain in the hands but it came out as I hoped so it's a win in my book
Looking good, looks like a bit of rework will get you there. I’ve found the handle of my engine crane is handy for bending smaller radius curves around!
@@redfoxclassics thanks for the tip
Good start. Looks good.
The trough on the new part looks a little too narrow as compared to the original. Granted no one will see it under normal circumstances, but you'll find fitting it easier the closer to original profile you can get.
@@drivewayshop it's tough to tell, but it does match the contour gage pretty closely. When I cut out the old section it'll be much easier to know how close it is.
@DavidPlass could just be the lighting in the video.