DC Constant Current Electronic Load Battery Tester 35875 TE

www.mpja.com/DC-Constant-Curr...
Snap-in panel meter/Load for testing and conditioning batteries.
Input Voltage: 5.0-30.0VDC (Polarity protected)
Load Voltage: 1.5-25.0VDC (Polarity protected)
Load Current: 0.00-5.00A 0.01A Resolution
Load Power: 35W Max
Current Regulation: ±(1%+3digits)
Voltage Regulation: ±(0.5%+1digit)
Over Voltage protection (OVP): default 25.2V (Adjustable)
Over Current protection (OCP): default 5.1OA (Adjustable)
Over Power protection (OPP): default 35.5W (Adjustable)
Over Temperature protection (OTP): ~ 80°C (Fixed)
NOTE: Display will flash & display the Fault; i.e. OVP, OCP
Low Voltage protection (LVP): default 1.5V (Adjustable)
NOTE: For Battery Discharge Test:
Setting the LVP value can prevent battery over discharge
Operating Temp: -40 to 85°C
Auto Start Fan when the power is greater than 10W or the temperature is greater than 40°C
L: 79mm W: 43mm D: 56mm WT: .3

[@tbiowa9977]

Great instruction video! Thanks

[@calumknott3519]

Thanks for this video, very helpful, are the settings saved when you power the device off, or do you need to reset the paramaters each boot?

[@user-ih8xp6dy4r]

Ок

[@dojmike]

Do you have the power supply specs to fire the unit up? Voltage as well as minimum amps? Thanks.

[@mpjaonline]

With the fan running it can draw ½ Amp at 12vdc, Here is a link to the datasheet. www.mpja.com/download/35875tedata.pdf

[@gunnaralv]

Its up to 30V

[@tpcdude]

You didn't show how you were powering the unit itself, maybe that was obvious but where do the battery leads go? can you use a 9v battery supply?

[@mpjaonline]

Look at about 28 seconds into the video to see where power is connected. It will work with a 9v battery but at a 25mA load it will only last about 20 hours.

[@ibringthelastwords1358]

Does this accurately measure the real capacity? thanks

[@gunnaralv]

Why does it drop voltage so much? Now I am testing a LiFePo4 battery, but at 1A it drops voltage from 3.3V to 1.61V. So UVP will kick in before it has drained the battery to its limit.

[@mpjaonline]

I can’t answer why your battery drops so much with a 1Amp load with out a lot more info. You can change the factory LVP set of 1.5v In the video it is at 7:15

[@rcmodellingau5353]

You are unfortunately, the owner of a dead battery. If you flatten a LIFE battery you will kill it.

[@guylechat1124]

Hello 👋. you talk a lot, but my knowledge is nil. so if you could tell me what is connected left and right. THANK YOU FOR BEING HERE ❤️ hello from Europe 👋.

[@freytube1]

canit be set to constant current in MA range ?

[@mpjaonline]

Yes and no, minimum resolution is 10mA with an accuracy of +-1% and 3 LSD make it possible up to 40mA off. Thanks, MPJA

[@freytube1]

@@mpjaonline thank you