DIY Roll Cage Fabrication Vintage PORSCHE 911 | Lessons Learned START To FINISH
ฝัง
- เผยแพร่เมื่อ 6 ก.ย. 2024
- Here's my first weld-in roll cage attempt for my Porsche 911. DIY roll cage fabrication is not for the faint of heart, which is why I started with electrical conduit and pool noodles! #fabrication #rollcage. You will need a good quality tubing bender such as the JD Squared in this video. No tubing was scrapped which is a miracle as a beginner.
This video is a complete guide showing the following steps start to finish.
a) Planning
b) Bending
c) Notching
d) Welding
e) Painting
f) Install
JD Squared Bender Used: amzn.to/2TY0gCD
#vintagePorsche #Rollcage
Patreon / ahhgaragetime
Insta @ahhgaragetime
FB / ahhgaragetime
Website www.ahhgaragetime.com
chill. by sakura Hz / sakurahertz
Creative Commons - Attribution 3.0 Unported - CC BY 3.0
Free Download / Stream: bit.ly/chill-sa...
Music promoted by Audio Library • Chill - sakura Hz (No ...
Snowfall by Scott Buckley / scottbuckley
Creative Commons - Attribution 4.0 International - CC BY 4.0
Free Download / Stream: bit.ly/2C39hQR
Music promoted by Audio Library • Snowfall - Scott Buckl...
Liking the idea of removable /bolted in side door bars.
Yeah, the side bars can be removed in about 5 minutes or less. I went through a lot of extra work to make the bolted connections as rigid as possible. Not sure how much that increases the stiffness of the car or not.
Nice work!
Thanks John😀
Well for a first time rol bar it looks pretty nice! Great work...
Thanks, I kind of hid it in black paint, but It came out ok.
these comprehensive project vids are cool. 🤘🏼 keep up the good work.
Thanks Grant! This was meant for new subscribers, but I'm so glad you watched too!
Awesome, Tom! Odd to see the car in primer again...
Weird huh,. Saturday's vid is about sanding again, ugh.
you sure gave me some good inspiration on the door bars! . and specific regulation rules you followed?
Cool, check out FIA, NASA, and SCCA if you haven't already done so
I’m not an expert but every track event tech inspection I’ve worked at the required distance was measured from the driver’s helmet. I know of taller drivers that removed seat bottom upholstery to meet that spec.
Makes sense. I put the main hoop as far back as I could and lowered the seat to the floor. I should be ok.