Nazgul5 v2 ELRS Installation

[@name_low]

Trop bien la vidéo continu comme sa 👍🤙

[@focalpointvideo]

Great video!
My Evoque came with the DJi 03 Air unit & I planned to use my DJI controller. I have since bought the RM Boxer with ELRS, can I just add the iflight ERLS RX THEN BIND?
My Q is so I have to disconnect the air units receiver in any way?
Thanks so much
Brent.

[@smokingtrez]

Just curious if the nazgul5 V3 version would be the same as the one in this video??? I would have to add a new XT 60 connector if you remove all of that stuff???

[@isaacschultz5056]

The process would be the same. Just make sure you connect the new receiver to the exact same spot as where your old one was (RX to TX, and TX to RX). Or if that's not an option, connect it an open UART that support it. There shouldn't be any need to add a new XT60 - I would keep the existing one on

[@tumax4534]

Do you have a test video? Or can you tell me how good is the receiver?

[@isaacschultz5056]

It’s quite good. I’d recommend one with an antenna instead of the one used in this video. With an antenna, I can get about 2 miles of range

[@tumax4534]

@@isaacschultz5056 nice, so should i get one of these or are there more better examples for Nazgul 5 v2 ?

[@isaacschultz5056]

@@tumax4534 the one that I linked in the description will work very well, I’d recommend

[@VinzFZX]

I have a question about this frame, how can i contact you ?

[@isaacschultz5056]

Email me at [e-mail]