L322 2010-12 Range Rover Supercharged Hood Sensor fix location

แชร์
ฝัง
  • เผยแพร่เมื่อ 23 ม.ค. 2025

ความคิดเห็น • 28

  • @albertvaldez4095
    @albertvaldez4095 10 หลายเดือนก่อน +1

    Mr Hill. Kudos to you Sir. Problem solved. I found the OEM sensor and paid $60 US, installed and that pesky bothersome red triangle on the dashboard is finally gone. Again, thank you for sharing!

  • @Frank99999
    @Frank99999 6 หลายเดือนก่อน +1

    Thank you, Mr. Hill! I just bent the sensor on my car and the warning sign gone. It was easiest DIY ever 😂 Had been dealing with this problem for more than a year

    • @TomOnEverything
      @TomOnEverything  6 หลายเดือนก่อน +1

      @@Frank99999 glad it helped!

  • @thomassachariason212
    @thomassachariason212 ปีที่แล้ว +1

    I drive a 2012 and have been getting the "hood open" warning on and off for the past few weeks. After double checking it was latched, I figure the sensor was just going out. After your video, I pulled up on the bracket which raised the button a few millimeters. Saved me time and money. Big thanks!

  • @elliot3811
    @elliot3811 10 หลายเดือนก่อน +1

    Thank you! I was getting anoyed that there is loads of videos on the sport but not for the Vouge! Really helpful video. Mines started doing the random alarm...

  • @andylinton2798
    @andylinton2798 10 วันที่ผ่านมา +1

    That was very useful - mine was doing the same, I couldn't find the switch! I just bent the bracket up a little and it fixed it! Thanks!
    BTW: My sensor is in the same place as yours, even though a RHD car.

  • @acollins8775
    @acollins8775 ปีที่แล้ว +1

    Thanks for this video! This has been happening for the last week and was ready to buy all new latches, etc. I just tried this and voila! Took 20 seconds! Gread vid.

  • @FactsMattersUSA
    @FactsMattersUSA 5 หลายเดือนก่อน

    Nice job, another fix for that bonnet (hood), is to simply pull the connector and install a wire inside the switch to bypass the warning light. Works like a charm.

  • @H2ON_MEA
    @H2ON_MEA ปีที่แล้ว +1

    Good job you did, and thank you for sharing . I have 2004 (2002-2004) HSE and the sensor in the opposite direction. Also I see a video for 2005 it is in the same your location.

  • @nevillebrooker9644
    @nevillebrooker9644 ปีที่แล้ว +1

    Hi.
    Caged mine today after exact same symptoms. Bonnet open and random alarms.
    Easy job to change..... and so far so good.

  • @marklandry4271
    @marklandry4271 ปีที่แล้ว +1

    Thanks for a great video, so I finally looked in the right place and found the sensor which has now been adjusted and given the old WD40 treatment - fingers crossed. Although the battery is on the other side, I located the sensor in more or less the same position as in your video despite being a subscriber to driving on the 'correct' side of the road ;-) Thanks again.

  • @troyfr
    @troyfr 27 วันที่ผ่านมา +1

    Thanks a lot you helped me solve this same problem!

  • @HoldMyBeerplz
    @HoldMyBeerplz ปีที่แล้ว

    omg!bro, you saved me! my 2012 range rover bonnet alram went off for a good while like a month the battery was almost draining dead until i saw your post. thank you!

  • @ChrisSF2G
    @ChrisSF2G 7 หลายเดือนก่อน +1

    Video was helpful will try this solution just happened to me also had the battery replaced about 10 days ago and they didn't put the trim under the front glass back properly. It's been raining like crazy and 95 degrees for a week was thinking it was the heat but hopefully it's the sensor out of line Thanks

    • @TomOnEverything
      @TomOnEverything  7 หลายเดือนก่อน

      @@ChrisSF2G 98% sure it is 😂

  • @keithlawson7469
    @keithlawson7469 2 ปีที่แล้ว +1

    Thanks for the location to the hood sensor. Did you check the pressure of the spare tire located under the floor of the cargo area?

  • @tigervo1956
    @tigervo1956 ปีที่แล้ว

    Thank you for this!

  • @Montrey2
    @Montrey2 ปีที่แล้ว

    Thank you so much!

  • @Irbalessence
    @Irbalessence 2 ปีที่แล้ว +1

    This is exactly what I need Thank you!!
    Do you know the name of the part or even a video on how to replace it?

    • @TomOnEverything
      @TomOnEverything  2 ปีที่แล้ว

      Didn’t need a part. Just bent the bracket to be flush with the hood so it would seat properly

  • @eddiebashir8310
    @eddiebashir8310 2 ปีที่แล้ว +1

    Thank you

  • @cretiatucker6397
    @cretiatucker6397 2 ปีที่แล้ว

    Hi I can’t find it on my 2013. Having the same problem

    • @TomOnEverything
      @TomOnEverything  2 ปีที่แล้ว

      Sorry I just saw this. I’m not sure on 2013 as the body style changed. Do you have the full-size or sport?

  • @jfsalgado7489
    @jfsalgado7489 ปีที่แล้ว +1

    With thanks---appreciate

  • @bradleykessler8563
    @bradleykessler8563 2 ปีที่แล้ว +1

    Thank you!!!

  • @EnockAlex
    @EnockAlex หลายเดือนก่อน +1

    left comment I guess it was deleted thanks tho

  • @myataylor2122
    @myataylor2122 หลายเดือนก่อน

    Thank you