I don't suppose you caught any images of where the blend door was when you had the blower out? My blend door actuator wont switch to cool so my air con is not getting to the vents. Tested the air con system and that's all nicely pressured up and gets ice cold but inside the car we're only getting hot air. I'm assuming the blend door will be just by the blower you removed?!
Hi Paul, sorry, I didn't capture that. However, its only a few screws to drop the blower motor so it shouldn't be too much of a pain for you to gain access and find out... Good luck...
As you say, I would certainly expect the same setup on the opposite side. It really is a very simple fix and I would encourage you to give it a shot. Do let me know how you get on…
Would it not have been more prudent to test the heater motor first using your meter or puting 12 volts through it. Save buying what you dont need and if working for the same money you could have a new resistor (Which is usualy the cause, I have changed mine 3 times over the years and is normally in stock at most motor factors like Swedish, german & french or Euro car parts).
Great question… before the blower motor packed in I had a blocked front drain point (below windscreen and above gearbox) where leaves and debris had gathered. Accumulated rain water had over spilled into the passenger footwell which was the obvious cause. I had already fixed that a month before the blower motor issue!
Where are the fuses I should check before doing the rest of the job? Thanks for the excellent video!
Fantastic Really informative
Thanks my friend !
Great Really Informative
I don't suppose you caught any images of where the blend door was when you had the blower out? My blend door actuator wont switch to cool so my air con is not getting to the vents. Tested the air con system and that's all nicely pressured up and gets ice cold but inside the car we're only getting hot air. I'm assuming the blend door will be just by the blower you removed?!
Hi Paul, sorry, I didn't capture that. However, its only a few screws to drop the blower motor so it shouldn't be too much of a pain for you to gain access and find out... Good luck...
I'm looking into doing the blower motor on a slk230 left hand drive. I'd imagine it would be on the passenger side (right side)
As you say, I would certainly expect the same setup on the opposite side. It really is a very simple fix and I would encourage you to give it a shot. Do let me know how you get on…
Would it not have been more prudent to test the heater motor first using your meter or puting 12 volts through it. Save buying what you dont need and if working for the same money you could have a new resistor (Which is usualy the cause, I have changed mine 3 times over the years and is normally in stock at most motor factors like Swedish, german & french or Euro car parts).
I had a high level of confidence that the motor was dead before buying a replacement and the overall fix was cheap and efficient...
Why was there water in there? And how do you fix that problem?
Great question… before the blower motor packed in I had a blocked front drain point (below windscreen and above gearbox) where leaves and debris had gathered. Accumulated rain water had over spilled into the passenger footwell which was the obvious cause.
I had already fixed that a month before the blower motor issue!
Hi Chris how did you fix that