VW Vanagon Fuel Injector Replacement - Marcos Injectors
ฝัง
- เผยแพร่เมื่อ 3 ม.ค. 2020
- Replacing fuel injectors on a Volkswagen 2.1L digifant engine
Buy the injectors from Marcos - www.thesamba.com/vw/classifie...
Also find me at:
/ notvanpron
/ notvanpron - ยานยนต์และพาหนะ
![fellow fellow - Proud [OFFICIAL MV]](http://i.ytimg.com/vi/9uZF7BlUQPE/mqdefault.jpg)
Thanks for sharing! I just bought these from Marco and will be installing next week.
I hope they are treating you well.
Nice Vid!!! Keep up the good work!!!
Thanks!
thank you!!
You're welcome!
I'd love to see your new fuel line setup
It is very sexy LOOKING but not real practical as it doesnt have proper releave fittings in it. (too much hard line). I am going to go back to something closer to stock when I swap the engine.
Great job. The wire to the fuel injectors look brand new. Are the part of a new wiring harness?
Ya I just swapped out my harness for the VanAgain harness. I have a video on swapping that out also.
@@notvanpron4115 I noticed your other video after my first comment. Thanks. I'll watch that video next.
How do you know when to replace your injectors ? test them for spray pattern ? Vanagon sitting for 10 years ??
Yes and yes. You can get them tested. I just new I had old injectors and it was time. If you have OEM injectors it is work it to get a set of mansi injectors or just replace them.
Were did you get the fuel rail
It was made by my machinist/welder friend. Going to have to upgrade/fix it in the long rung as it is too stiff.
Any idea where I could get these injectors now? His ad on the samba is gone.
He has a website now, mansispeed.com
@@notvanpron4115 amazing thank you! Turnkey turbo kits waaaaa?
@@clevelandmotley Ya I follow some of his amazing posts on fb
@@notvanpron4115 what the handle on facebook?
So...what are your thoughts on performance?
Honestly, It does run smoother but I have other electrical (ground) problems that it is covering much of the improvements. I should have some time this weekend to work on my ground issues.
I just did all my grounds. Somehow get a dremel on a cable. Use a cone shaped wire brush and get to all your connections. Take them apart one at a time, wire brush connectors and mounting location. Cover connectors and everything with die electric grease and re install. I clean the screw too. One large ground on left of engine, one under front of transmission, and a few under the drivers dash.
Any further thoughts on performance or fuel economy?
@@nuggethikes Electric grease is NOT conductive. Smearing it on the parts before assembly is not the right way to use it. First you reassemble your parts, then you protect the assembly with the die electric grease
Can I still buy Marcos injectors? anyone have a link? thanks
Get them here:
mansispeed.com/