@@tashnim98 there will be resonance "metal" sound on this board. You could use plate file only to help abit. It's a plastic board, there's not much you could do about it. FR4, will be muted.
@@tranphuocloc7972 Are you looking for clack or thock? With foams, it will be muted and thocky to add on to flex cut PCB. You can try using without any foams. It should be clacky. Also to note, each board sounds different and has its own characteristic sound signature. I could not comment on Crush80 as I have not tried it before.
@@s_keebs or the beige one! However, the remaining PCB left is 1.2mm I guess I'll have to wait for the re-run if any. I tried running foamless with all the flex cuts and it sounded very thin and excessive bounce.
The craziest thing is that the keycap set is more expensive than the keyboard.😂
I wonder how this switch using alu plate on this board. Because i cannot made my mind whether to go for alu or fr4
@@tashnim98 depends on what sound signature you're leaning towards. I'd go for alu
@ i want to go for clacky but im afraid the “metal sound”
@@tashnim98 there will be resonance "metal" sound on this board. You could use plate file only to help abit. It's a plastic board, there's not much you could do about it. FR4, will be muted.
What plate is the best for kailh bcp. I am using crush80 with alu flex cut plate, the sound is horrible. How to make sound better?
@@tranphuocloc7972 with foam? Alu usually should be fine. Have you tried with PC or PP?
@@s_keebs yes stock foam. Ixpe foam, what is diffirent between pc and pp. I dont have idea about flex cut make sound horrible?
@@tranphuocloc7972 Are you looking for clack or thock? With foams, it will be muted and thocky to add on to flex cut PCB. You can try using without any foams. It should be clacky. Also to note, each board sounds different and has its own characteristic sound signature. I could not comment on Crush80 as I have not tried it before.
@@s_keebs i like clacky sound. Do you think which plate is good to use kailh bcp. I love the sound of bcp, i dont know how to make this sound clearly.
@@tranphuocloc7972 Alu or CF without foams. You can tape your flex cuts with Painters Tape
is this top mount or gasket mount?
Gasket mount.
I see you got the new 1.6mm PCB hmmmm.....
@@DadTech1981 Yes, it was available for a moment on their website for 6.25u & 7u!
@@s_keebs I saw that but I was thinking twice because I already have the initial release with the 1.2mm flex cut PCB lol
@@DadTech1981 Unless you get the Transparent Black set as a 2nd set..😜
@@s_keebs or the beige one! However, the remaining PCB left is 1.2mm I guess I'll have to wait for the re-run if any. I tried running foamless with all the flex cuts and it sounded very thin and excessive bounce.
@@DadTech1981 I was looking at the beige too. I also gotten a FR4 from Hyperboring. Too bad Alu was OOS.