Riddle me this

ABS, 275C base section, 255 below the hat, 500/30k/30SCV/.01PA/0.12 layer height/14 min/
Filament is dry.. does it fast, slow, medium.
Always a riddle with these things.
UPDATE:
Printed 3 of these with 0.0PA, 0.01 PA, 0.022 PA. 0.0 had the most scars, .022 had many also, .01 light scarring, but still scars on the hat.
Sliced again in Cura(using Super slicer most of the time), same settings, same time, same all.. no scarring on the hat, very light scarring on mouth and some very light scarring on the right eye. The rest is flawless.

[@SparkyBrownCow]

I had this recently on Goliath +Micro Sherpa + Breakneck toolhead. It occurred near the seam, so I assumed it was loosing material by oozing over the travel move.
I couldn't eliminate it entirely, but increasing the PA smooth time from 0.02 to 0.03 helped a bit.

[@damianomotta1809]

maybe retraction compensation to fill the seam better?

[@MrRocksalt]

THose places have no retraction. Only at layer change. That model printed flat, so those lines on the hat are on plane with the bed.

[@daliasprints9798]

0.01 PA is way too low for 0.12 layer height. It should probably be around double what you use for 0.2-0.25 lh

[@MrRocksalt]

I made 3 prints. 0.0, 0.01, 0.022. 0 was the worst, .022 was the second worst, and .01 was the best. Corners are sharp at 0.01. At -0.022 the corners look like over heating or some other. 0.018-0.022 was the sweet spot and now is .007-.010.