4 Bolts right there were he was spray. Remove the 4 bolts, take the throttle body off, and clean it with throttle body cleaner, and a soft toothbrush. The throttle body will then be clean, no junk inside the intake causing a lot of smoke, and it will idle properly again when done.
Might need an idle reset after disconnecting the throttle body on Trailblazer/Envoy. After 2007 there's some extra stuff they put in that made it even more complicated (so I read). Also read there's a DIY way to perform an idle reset using a pedal/ignition combo and doing a bit of highway driving.
I find it hard to believe he has cases of this stuff and he doesn't know the difference between a throttle position sensor and the throttle body. Then later he claims to not know the price of a can of the stuff. If he bought cases, you would think he knows how much the stuff goes for.
Yea, it's like what, 4 or 5 bolts and 5 minutes maybe? This guy is just crazy. Take off the throttle body and skip the pricey foam. $2.99 carb cleaner, half a can.
JayzBeerz.... Actually by doing what he did and with what he used may very well have helped remove some carbon buildup in the intake, valves and or cylinders. I also think that Amsoil have a much grasp on the technology than you or I!
I keep getting the evap solenoid failure or stuck open code, I've replaced it three times. Every time I replace it, it works for a few months then does what you're talking about. If the AC is off it's fine. Solid idle, if I turn the AC on it dips and rises, dips and rises, espically coming to a stop sign or light... It's embarrassing especially in the car line at school haha. Will have to try this
So that's how they do special effects smoke screens and fog in the movies. For someone whom claims to do this often, I watched intently and I could not see where you actually sprayed sufficiently into the very forward part of the throttle body. However, even with that (appearance) to lack of attention and application, I likely would have begun as you did. Spray and Soak for 10 minutes, Re-spray and and use a nice tooth brush to work around both the throttle body and plate. Spray again and let sit for 5 or so minutes and then start the vehicle and burn off!
I got a 2002 chevrolet blazer xtreme (49k miles) just. Cleaneded the maf sensor as it threw a p0101 (accompanied by p0172 &p0175 banks 1 & 2 rich) cleaned the maf and now it idles at 600 rpm fine but if i kick the ac on it falls on its face and almost stalls. It runs fine without the ac on and doesnt restrict itself it did sit for a while before i bought it. So im just assuming i need to clean the system run some seafoam or amsoil through it.
Mark Chase - I know I'm a bit late but if you're still interested in AMSOIL products visit my page at Facebook.com/bestmotorlube , my contact information is listed there and there's also a link to order AMSOIL products online.
John Muller - www.amsoil.com/shop/by-product/other-products/antifreeze/passenger-car-and-light-truck-antifreeze-and-coolant/ If you would like more information about AMSOIL products you can visit my page at Facebook.com/bestmotorlube
This video was just advertising power foam guys never clean the throttle body like this guy did all that crap getting sucked into the engine. Do it right take the throttle body off and clean it right or just spray in with brake clean and wipe it up with a towel
I have an 06 Chevy trailblazer that shimmies when I come to a stop but only with the ac on. Will this possibly help stop that? Could the O2 sensor be bad?
I have noticed everyone comments about taking the throttle body off! Heck! I am in this situation because AAA spryed cleaner though the plastic cover and called it good! It was running perfectly and smoothly before having them "fuel system" fluid change! After, I had to take it back! The manager offered nothing! And left the assistant manager holding the bag to deal with an irate customer! So if this shop is getting away with it, by just spraying it into the throttle body while attached. Are other shops really taking it off?
Depends on the service. If you had a fuel system cleaning they won’t remove anything and hook it to an evap line in the intake. If you have an actual throttle body cleaning it usually gets pulled off and cleaned on a work bench.
He makes a statement that all they did was spray a "little bit" of foam.... Actually no, it was a whole can! And the proper thing to do would have been to remove the throttle body and clean it rather than letting all this crap get run through the engine... That's not the way to do this job. Additionally he Throws around numbers of how much the can cost and then And then says he doesn't know What it costs.... But yet in the beginning of the video says he has cases of the stuff, And yet he doesn't know how much it costs,...???
Clean your MAF, MAP; Remove TB and clean on bench. IF it's the TPS, a new TB will be needed. Abt. $140 @ Amazon. I've been thru all this. 2008 Envoy SLE.
you really should take the throttle body off of the car to do this! all qf that shit you are cleaning off is going into your cylinders and valves sensors!!!
Wait he has "cases" of this cleaner but doesn't know how to clean it properly? F this guy for releasing a highly excessive amount of chemicals into the environment.
4 Bolts right there were he was spray. Remove the 4 bolts, take the throttle body off, and clean it with throttle body cleaner, and a soft toothbrush. The throttle body will then be clean, no junk inside the intake causing a lot of smoke, and it will idle properly again when done.
I already did it and the problem continuos tha samev😮
This fluid may damage the coil insulation. Better to remove the throttle body for cleaning.
Might need an idle reset after disconnecting the throttle body on Trailblazer/Envoy. After 2007 there's some extra stuff they put in that made it even more complicated (so I read). Also read there's a DIY way to perform an idle reset using a pedal/ignition combo and doing a bit of highway driving.
Just 4 bolts and you could remove the whole throttle body. The bolts are right there.
Brooo! Take that thing off an clean it
THROTTLE BODY, NOT TPS... FOUR BOLTS KEPT YOU FROM DOING IT RIGHT
I find it hard to believe he has cases of this stuff and he doesn't know the difference between a throttle position sensor and the throttle body. Then later he claims to not know the price of a can of the stuff. If he bought cases, you would think he knows how much the stuff goes for.
No kidding. Easier just to do it right. Plus you won’t have to worry about throwing a check engine light for o2
Ya i took mine off and got a toothbrush in it
Do not do this!! Take off throttle body and clean with throttle body cleaner with toothbrush
Where can i find those green locking tab on the wire harness, I lost mine. Thanks for the video sir.
Anybody know what the wire harness on the driver side of the back 2 coilpacks go to? If i tap mine it kicks on my reduced power light...
laziness take the throttle body off and spray it down with choke cleaner and wipe it off. you don't want that deal getting in your engine.
I agree 110% with you!! LOL That would put more carbon in you hole system of you engine AND your muffler and pipes! Right? LOL
Yea, it's like what, 4 or 5 bolts and 5 minutes maybe? This guy is just crazy. Take off the throttle body and skip the pricey foam. $2.99 carb cleaner, half a can.
Hydrolock?
JayzBeerz so true .
JayzBeerz.... Actually by doing what he did and with what he used may very well have helped remove some carbon buildup in the intake, valves and or cylinders.
I also think that Amsoil have a much grasp on the technology than you or I!
Can i use my 2003 Old mobiles bravada, with Amsoil Power Foam for Throttle Body Clean like how you show?
?
Gracias me atudo bastante
I know I probably sound dumb asking, but throttle body cleaner is okay to use as well right? Same stuff?
Boi...your gonna tear somebody car up....
You fired, automatic weapons. New subscriber.
I keep getting the evap solenoid failure or stuck open code, I've replaced it three times. Every time I replace it, it works for a few months then does what you're talking about. If the AC is off it's fine. Solid idle, if I turn the AC on it dips and rises, dips and rises, espically coming to a stop sign or light... It's embarrassing especially in the car line at school haha. Will have to try this
This stuff may damage the throttle body coating. Use throttle body cleaner for this task.
it is throttle body cleaner
So that's how they do special effects smoke screens and fog in the movies.
For someone whom claims to do this often, I watched intently and I could not see where you actually sprayed sufficiently into the very forward part of the throttle body. However, even with that (appearance) to lack of attention and application, I likely would have begun as you did. Spray and Soak for 10 minutes, Re-spray and and use a nice tooth brush to work around both the throttle body and plate. Spray again and let sit for 5 or so minutes and then start the vehicle and burn off!
Omg my mind is blown thank u
I got a 2002 chevrolet blazer xtreme (49k miles) just. Cleaneded the maf sensor as it threw a p0101 (accompanied by p0172 &p0175 banks 1 & 2 rich) cleaned the maf and now it idles at 600 rpm fine but if i kick the ac on it falls on its face and almost stalls. It runs fine without the ac on and doesnt restrict itself it did sit for a while before i bought it. So im just assuming i need to clean the system run some seafoam or amsoil through it.
Did you figure this issue out?
@@jasonsimpson9206 mass airflow sensor had been swapped out prior with a duralast one
I cannot find any parts store around the Raleigh NC area that carries this product, how can I get it?
Mark Chase - I know I'm a bit late but if you're still interested in AMSOIL products visit my page at Facebook.com/bestmotorlube , my contact information is listed there and there's also a link to order AMSOIL products online.
Guess I'm old school but all the garage varnish and deposits gos through the motor and on the plugs take it out and clean it
since i replaced my throttle body i would want to spray the IAC secondary control valve with this if i can find where its located...
Do you have a link for Amsoil antifreeze? Thank you!
John Muller - www.amsoil.com/shop/by-product/other-products/antifreeze/passenger-car-and-light-truck-antifreeze-and-coolant/
If you would like more information about AMSOIL products you can visit my page at Facebook.com/bestmotorlube
guess I need to do this
This video was just advertising power foam guys never clean the throttle body like this guy did all that crap getting sucked into the engine. Do it right take the throttle body off and clean it right or just spray in with brake clean and wipe it up with a towel
I have an 06 Chevy trailblazer that shimmies when I come to a stop but only with the ac on. Will this possibly help stop that? Could the O2 sensor be bad?
It's not shimmying it's put putting because she needs her throttle body cleaned.
I have noticed everyone comments about taking the throttle body off! Heck! I am in this situation because AAA spryed cleaner though the plastic cover and called it good! It was running perfectly and smoothly before having them "fuel system" fluid change! After, I had to take it back! The manager offered nothing! And left the assistant manager holding the bag to deal with an irate customer! So if this shop is getting away with it, by just spraying it into the throttle body while attached. Are other shops really taking it off?
Depends on the service. If you had a fuel system cleaning they won’t remove anything and hook it to an evap line in the intake. If you have an actual throttle body cleaning it usually gets pulled off and cleaned on a work bench.
Next up... o2 sensor check light coming on
What's that doing to the catalytic converter ?
No Favors.
Why does it idle like a diesel engine
You're not afraid of messing with anything. I was making faces wtf!!
Well and now my suv is too. Ummm wow probably should have just took it off and cleaned it like i was gonna do.
Was it nessary spraying the whole can in a small area if less half of power foam doesnt do the job why waste money
Hydrolock?
He makes a statement that all they did was spray a "little bit" of foam.... Actually no, it was a whole can! And the proper thing to do would have been to remove the throttle body and clean it rather than letting all this crap get run through the engine... That's not the way to do this job. Additionally he Throws around numbers of how much the can cost and then And then says he doesn't know What it costs.... But yet in the beginning of the video says he has cases of the stuff, And yet he doesn't know how much it costs,...???
Tried this it still stalls just not as fast. What do I do now?
Clean your MAF, MAP; Remove TB and clean on bench.
IF it's the TPS, a new TB will be needed. Abt. $140 @ Amazon.
I've been thru all this. 2008 Envoy SLE.
Spraying the whole damn can?
At least half.
you really should take the throttle body off of the car to do this! all qf that shit you are cleaning off is going into your cylinders and valves sensors!!!
what to do in diesel vehicle ?
Is same job .
😨
That's not the throttle position censor
Power Foam Baby
Take the throttle body off u could of hydrolocked the engine 😅😂its like 8 bolts total
You’ll be doing that in a couple weeks again doesn’t last that long
My envoy died when you turn the heater on
You should not spray so much a towel useful
Mannn might be bad
More advertising annoying
Looks like sea foam
This is RIDICULOUS - remove tb FOR EASY CLEANING W cARB CLEANER = proper
All you need to do is clean it. This is the worst advice. Their is a relearn procedure.
What not to do video.
Wait he has "cases" of this cleaner but doesn't know how to clean it properly? F this guy for releasing a highly excessive amount of chemicals into the environment.