Sur Ron Light Bee Segway X260/X160 219 Primary Chain kit lower gearing (equal to +10T rear sprocket)
ฝัง
- เผยแพร่เมื่อ 3 มี.ค. 2021
- I ended up getting a nylock M10x1.0 nut from my local hardware store to replace my swing arm nut for 75 cents.
I used two spacers behind the motor sprocket.
219 Primary Drive Chain kit:
lunacycle.com/luna-primary-be...
Official Southern California Sur Ron / Segway Owners:
/ 514794349201145
Instagram:
/ socal_surron - ยานยนต์และพาหนะ
Very nice
The belts are tough, but there are some downsides. Mad, stones, grit, debris. SHOCK loading the belt by jumping and landing under throttle and suddenly slowing the rear wheel, will eventually shred teeth on the primary belt. If any of those things are the type of riding you do, get a chain primary.
What is the name of the tool to take it off instead the old hammer/ pliers? Link would be great . Txs nice vid
ebikezilla.com/en/chargers-tools/11001-swing-arm-axle-tool-sur-ron-lb-x-segway-x260-402140402-sur-ron.html
Luna cycle also has a swingarm wrench, but you have to email them directly about it. It comes with the belt drive kit.
The proper name of the tool is clutch nut socket. The M10x1 nut is called a castle nut, or clutch nut. It's an oddball size though, so any standard clutch nut sockets don't work, without modification. Best choice is to remove it with a punch and hammer, and discard it for a Standard hew M10x1 locknut.
Hey, any chance you know how to get a replacement for the x160 chain?
The secondary chain that goes to the rear sprocket?
@@skyungjae sorry 8m not sure of the names and everything 😖. But the long one with 56 links. I can't find it anywhere 😭
How many spacers did you put to the inside on the motor 2 or 3?
2
you should use 3.. they use 3 on luna website .. they have pictures
@@jerseyrotaries link? Their install information link shows the install for the 420 primary kit.
this kit is junk.. my sprocket is lopsided making the chain loosen and tighten when spinning ..
My chain tension doesn’t change through the full rotation. Maybe your motor isn’t aligned or you should go to 2 washers.
@@skyungjae the washers have nothing to do with it. Those are only for aligning the 2 sprockets.. the sprocket I got has a manufacturing defect.. the hole in the center of my large sprocket is a hair off ..
@@jerseyrotaries that’s too bad. Hopefully Luna makes it right.
@@skyungjae waiting to hear back.. crossing my fingers.. they should replace it, however they are out of stock so I might have to wait .. an auto chain tensioner would be cool ..
@@jerseyrotaries Their CS is usually pretty good. Nobody is a fan of the split sprocket design. It would be great to see an update to the design.