Rudy did one (or possibly you could have done it) for my B Deere last summer and with his short video on how to time it my B started and ran fine the first time. Great work.
Kenny hear is something I learned from a old mechanic friend by the name of Pretty Hancock!! He told me to scuff the gray glaze off of the points with 220 emery cloth because it will make the points last twice as long !!! And he was right !!! 😊👍🌎🌞 I like seeing a mag when you get done they look like new !!!
Yessir!! We always polish the points. Sometimes there is an oily film on them as well to protect them in the box from corrosion. Good that you bring that up.
As long as it is appropriately cleaned after blasting, you shouldn't have any issues. I have yet to run into an issue like that. Attention to detail is KEY!
![[Gegagedigedagedago] NEW Help Gegagedigedagedago Nugget escape from Nikocado Avocado Challenge](http://i.ytimg.com/vi/hJWnwRC2Fz8/mqdefault.jpg)
You probably could disassemble, clean and then reassemble magnetos in your sleep! You take pride in your work and that is greatly appreciated. 🇺🇸🚜👍
Some I can! Ha ha. There are many, many others I know very little to nothing about. But, only one way to learn!
Rudy did one (or possibly you could have done it) for my B Deere last summer and with his short video on how to time it my B started and ran fine the first time. Great work.
Very likely could have been me or Rudy's son. He's been helping out in the shop quite a bit as well!
Well done.
Thanks, Brad!
very good, clear video
Thanks, Randall. Glad you liked it!
Kenny hear is something I learned from a old mechanic friend by the name of Pretty Hancock!!
He told me to scuff the gray glaze off of the points with 220 emery cloth because it will make the points last twice as long !!! And he was right !!! 😊👍🌎🌞
I like seeing a mag when you get done they look like new !!!
Yessir!! We always polish the points. Sometimes there is an oily film on them as well to protect them in the box from corrosion. Good that you bring that up.
@@KennyKizzleRustyNutzRanch I was just wondering if you did 😉
Nice looking job, have you have issues with cleaning media getting trapped and ruining the bearings and or wear surfaces?
As long as it is appropriately cleaned after blasting, you shouldn't have any issues. I have yet to run into an issue like that. Attention to detail is KEY!
Do you work at rebuiltmags? I have two I need rebuilt and would like mine to look just like the one in this video.
Yes I do. I help Rudy out when my schedule allows. We can get you taken care of!
I have a howard gem rotavator, I need a new wico magneto, do they open source the plastic parts inside the magneto
Call Rudy at rebuiltmags.com most everything for wico mags is available
Where did you get the rebuild kit for this?
We sell all parts necessary to rebuild the magneto at rebuiltmags.com
You mention recharging the magnet at the 10 minute point, how did you recharge it?
We have a magnet charging station.