The edge and orings should use loctite 518 (or permatex equivalent), not black rtv. Also, i also re-used old thrust washer as mine was too thick as well. Also, you need to use loctite 518 around the surface of the oil seal and put grease inside the lip as per the manual.
No the new thrust washers from the kit I bought was a diffrent thickness then the original one I just re used the original thrust washer . Side note are you Ron Beauchamp son? Turn left!!
very well explained. i only wish u had a camera holder. i am old and visual aids are very helpfull.
Very helpful thanks for taking the time out to sharing about to buy a ski with pump issues
No problem got a few other pump rebuilds for a few other skis as well
Muchas gracias amigo. Muy bien explicado y facil de entender. Ni siquiera necesité usar el traductor.
The edge and orings should use loctite 518 (or permatex equivalent), not black rtv. Also, i also re-used old thrust washer as mine was too thick as well. Also, you need to use loctite 518 around the surface of the oil seal and put grease inside the lip as per the manual.
2 more videos coming out this week be sure to check them out as well thanks guy's
Thanks
Nice job man!
I heard the Yamaha's come with a Pratt and Whitney F119 PW 5000 jet propulsion unit. Only one though... is this comparable?
Yes faster then any boat out of the water
You're driving down the highway on a jet ski, when a wheel falls off. How many pancakes does it take to cover a doghouse?
@@genderization 6 er 9
Purple, cuz Ice Cream has no bones....
Great vid man thanks! Lots of details here you don’t find on other vids.
What happens if you put the wear ring with the lip down 😅
It won't seal properly to the hull when you put your pump back on and could cause power loss wile riding
😅 men going to have to buy another one 🤦♂️ didn’t notice until I went back and read the book and new oil as well 😅 🤦♂️
Good afternoon, what oil do you use to put the black oil bottle in the jet cone, what is it and what grade?
It's just some canadain tire outboard gear oil it's just 80w-90
How did you pound those two bearings out? Pound outside in or from inside out?
From the inside out if you do it the other way it will be hard to get out
Can't pound it and hold the camera at the same time? Rookie.. lol jk thanks for the vid
Same shaft you just didnt install it right
No the new thrust washers from the kit I bought was a diffrent thickness then the original one I just re used the original thrust washer .
Side note are you Ron Beauchamp son? Turn left!!
is my ride supposed to just come out like that
Your ride? You mean the impeller shaft?
That's not rebuilding a jet pump that's just replacing the shaft and racer bearing
And wear ring. That is rebuilding the jet pump lol