Nice grouping with the Knockout slugs, I've always said those slugs are great! My Maverick does really well with them, and so far I haven't found any other better slug. Subed to your channel brother! Keep up the good work!! 👍🏼
I know. The BC was set at 10,4 but still going high. With pellets set to +/- 4,5 it works great. The fault was o-ring inside the valve cylinder. Check my other video and www.rtiarms.shop/products/spare-parts-rti-prophet-ii
Actually the hammer spring should not be adjusted. You should find the spot where the valve just opens and then rotate it about 1/2 turn extra in. This makes the hamer less impacting the valve and the gun more accurate.
First of all your gun has way to much max spread. and how is t possible to have a bc of 10? and I wouldn't place videos with moving traffic just after your target. not doing the hobby much good
Nice grouping with the Knockout slugs, I've always said those slugs are great! My Maverick does really well with them, and so far I haven't found any other better slug. Subed to your channel brother! Keep up the good work!! 👍🏼
Thanks a lot
It is nice gruping, the grup is higher because the slug have better BC than pellet. So what was the identified fault that the air was leaking?
I know. The BC was set at 10,4 but still going high. With pellets set to +/- 4,5 it works great. The fault was o-ring inside the valve cylinder. Check my other video and www.rtiarms.shop/products/spare-parts-rti-prophet-ii
Yes, I was watching an enjoyed too. It is nice done. It is strong and precise tihis pcp.
im using the H&N 28g 249 slugs in .25 at around 970fps and there grouping very well
Ok I have those somewhere too. I will try them soon.
Good grouping 👍👍
Good video 👍.
What jsb were you using, 217 or 216?.
I've had good groups with Zan 23 gr, weather stops play for now.
Knock out testing next.
33,49gr 6.37mm knockouts Mk1
@@AirgunNL great group.
An apology, I thought you were shooting 5.5. i must wake up properly before watching in future.
@@garymurray5361 don't think I mentioned it specifically...😁
what is the the reg. pressure ? Hammer spring tension "Factory" ?
155 bar and about factory spring tension. Not sure since I took it apart.
Actually the hammer spring should not be adjusted. You should find the spot where the valve just opens and then rotate it about 1/2 turn extra in.
This makes the hamer less impacting the valve and the gun more accurate.
Would you say it's a better than the fx impact
Can't say. Don't have one, but it's much less complicated though...
It's not complicated like fx and yes I think it's better.
Bravo for RTI 👌👍😀😍
Will Slugs 22caliber work with a Quest Nite Ops Air Rifle from Crossman
Don't know
That's a great first group's. Is that a .22 or .25? That is thier new barrel right?
.25, yes the new barrel...
Is the performance edition? I want to shoot slugs to
Yes the performance edition.
Barrel on Mine is for Light Slugs Heavy Pellets
Good job..my frend...
What Speed in FPS did find Knockouts best at
I did not make a lot of adjustments. I shoot them around 930fps.
Is this the new slug barrel?
The new RTI barrel yes. Works excellent both for pellets and slugs.
I modified a 700 mm CZ barrel to fit the block of my RTI prophet .It shoots almost all kinds of pellets and slugs at different speed .
First of all your gun has way to much max spread.
and how is t possible to have a bc of 10?
and I wouldn't place videos with moving traffic just after your target.
not doing the hobby much good