ฝัง
- เผยแพร่เมื่อ 21 พ.ย. 2009
- Some gyro testing with the RX2609. Turn table is a CD with a brocken swash plate glued on it. Main motor is a HP08-2. This set up helped a lot to adjust the tail pitch. I put the gyro in normal mode and moved the tail servo until the heli stopped yawing. No fine trim needed now - can switch between normal and HL mode (for what reason ever :) without adjusting the fine trim...
Gyrosense at 0-49% = normal mode
Gyrosense at 51-100% = HH/HL mode
Gyrosense at 50% = gyro OFF! see: • Walkera 4G6 RX2609 Gyr... - ยานยนต์และพาหนะ
really good video, i'm glad someone is doing setup videos on this new heli. Could you make a video showing how you setup your tal servo with the rudder step by step and transmitter setting ?
Thanks, I saw the video and I am going to make one for myself. Great job
It looks like the gyro is functioning properly. Great job, How did you make that turntable? It looks like a cd somehow fixed to a vacumn type of vise. I would like to make such a turntable. Can you share your design?
Thanks
I am very new at this, the heli's I have been buying are 450 clones with a HH gyro. its a very simple 2.4ghz controller. my question is about the knob on the right that affects the gyro. it seems that in its middle position the gyro is basically off, when I turn the knob to the left the servo responds to counter the unwanted movement then recenters to where it was, and when the knob right of center, the servo responds and stays wherever it lands without centering. is one of these rate/hh mode?
do you have any idea why is my 4g6s two servos keep on stocking up even if it is not attached to the ball links? Thanks.
those aren't stock main rotors , are they aftermarket carbon bladesfor the 4#6? where did u get those ?
my 4g6s battery only last for a minute all new and old batteries. i don't know what the problem is? please advice. Thanks.