Will it Run? Briggs Intek 18.5hp V Twin
ฝัง
- เผยแพร่เมื่อ 17 มี.ค. 2021
- Car Jump Starter 800A Peak Flylinktech
amzn.to/3vFOptS
HULKMAN Alpha85 Jump Starter 2000 Amp
amzn.to/2OEMllw
Ignition Coil Replaces Briggs Stratton 592846 691060 799651 499447 for Intek V-Twin 18-22HP
amzn.to/3tvg9Q8
Briggs & Stratton 491055S Spark Plugs
amzn.to/3eMzU1A
492932S Oil Filter
amzn.to/3sc0fKt
Carburetor Replacement for Briggs & Stratton 20HP 21HP 23HP 24HP 25HP intek V-Twin Engine
amzn.to/2P9tY8c
Fuel Pump Replaces 691034/808281/692313/557033 808656
amzn.to/3vOQpAo
Air Filter 691035 Fuel Filter 696854 Oil Filter Spark Plug
amzn.to/3ls7yeg
Starter Motor Single Cylinder and V-Twin
amzn.to/3r0ckRt
www.amazon.com/shop/redneckco...
Redneck Computer Geek's Amazon Page
Shop recommended products from Redneck Computer Geek on Amazon.com. Learn more about Redneck Computer Geek's favorite products.
For shirts and stickers check out the online store
teespring.com/stores/mud-mowe...
/ redneckcomputergeek
Email me at mainemudmower@yahoo.com
Join my FB Group / mainemudmowers
Check out my FB page / redneckcomputergeek
Thank you! - ยานยนต์และพาหนะ
This vid needs more lubie dooby. I hit anything I work on a day before and then again when removing bolts. Another thing I did differently was to disconnect the kill wires to the coils and just use the fuel solenoid to stop the tractor which it does about three seconds after turning off the key switch. Maybe wrong for some of you ,but at least the carb stays dry
I’m in the middle of swapping my murray mud mower with the same engine. And I need help on wiring it up
What would be the best thing to do to boost the power and speed on a Bob Vila signature series 21 horse Briggs & Stratton V-Twin riding tractor
When you blew the engine out my eye started to feel irritated ive watch this before but I forgot how bad that was
Great Video... I had been wondering about the steps to take BEFORE doing any Cranking to it....I'm working on a 19hp V-Twin myself, that I picked up & had been sitting for awhile.. when I checked for compression by just turning by hand. I noticed that it does have both compression strokes but must have been stored on its side at one point because it has some oil coming from the exhaust pipe on the side it was leaned to. .... Should I just top off the oil and bottle feed it to see if it will crank over first? or tear it down and check out everything before cranking? and BTW.... glad your comment section is back to working again.
The irony of your oil problem is its the other side you need to worry about. If it was me I would pull both spark plugs and spray PB blaster or something of that category in the hole and turn it over a good 10 or so rotations. The first time you start it up expect it to smoke for a solid 30 minutes AKA do it outside.
@@redneckcomputergeek amigo me gustan tus videos no importa si hablas mucho LoL lol
Ok butt hwat a SCREEMING HALLOOOO
Only people who don't give 2 craps lay an engine on the ground sitting.