i have clima manual no bizone and missing white flap on on right side below . it is normal? moreover when switch on high temperature i have only warn air on left side while on right not ,it is seems tepid what happen????
Thanks for the video. I did a similar but simpler fix to get mine working again. MUCH quicker than removing and reinstalling the motor 1. The location of the motor is up under the glovebox. My car had a foam flap with a single holding screw which had to be removed first before what you can see in the video is apparent 2. The issue was the teeth on the gears had jumped (due to a stone in the flap), so like in the video the motor could not turn fully 3. Set the car temperature to full hot or full cold 3. A simple fix - pull the gear that drives the flap out just 2mm so the teeth no longer engage. 4. Then rotate the gear so the flap matches the motor either full hot or full cold. (The spindle will keep it locked to the flaps when you rotate it) 5. Push the gear back in so it re-engages with the teeth and clicks into place 6. Re-calibrate the heating and cooling. Now when you adjust the car temperature, the gear and the motor should rotate through the full range of motion and not get stuck Much quicker and easier than this video
I have a gear that pops out from the motor. I will re-install it again but wondering what can be the cause. You have mentioned a stone blocking the flap.
Hi there, nice video but i was wondering, i took out the one u took out from the car, i put the connector back in to ser if it goes around, it did. But the car is still blowing cold from the passenger side. Would appreciate feedback on that, what else could it be?
Hi. I have a 2016 Golf Mk7 GTD - I have noticed that the heater doesn't blow cold or hot air in the footwells. Any ideas how I could resolve this? Appreciate any help... Thanks
It’s most likely the same things. I have an audi a3 and have the same issue. there’s another motor on the other side. It’s more complicated to replace and believe that’s the one for the footwells.
Ahoj. Nefunguje mi kurenie, podla PC je chyba v module. Ale ked som vyzualne kontroloval tak pekne zasadne polmesiacik do zarezu a klapka ide na hot a takisto spät na cold. Ked dam ma max teplotu tak ide jemne teply vzduch...
Hallo ich habe fast dasselbe Problem ich habe einen Golf 7 kombi bj 2016 mein Problem ist ich bekomme links und rechts kalte luft also die Klimaanlage funktioniert aber in der Mitte kommt keine Luft mir sagte man dass der stellmotor defekt sein ist dass der selbe Fall wie im Video und wie lange dauert es uns was würde es kosten in der Werkstatt vielen Dank
to najstavenie studenej pozicie sa neda urobit aspon v mojom pripade nie, dolezite bolo to dajako nasmerovat aby ten stredny vystupok zapadol do tej bielej medzery co otvara klapky , takze podla navodu sa neda postupovat uplne
Thank you for this clear video! 👍 It was very helpful. I found that white gear wheel on the ground in front of the passengers seat and the right dashboard ventilation grill would only stream hot air. I placed the wheel back and now it's solved. I hope it will stay in it's place.
328197 - Motor for Right Temperature Flap B108D 54 [009] - Missing Calibration / Basic Setting Confirmed - Tested Since Memory Clear Freeze Frame: Fault Status: 00000001 Fault Priority: 2 Fault Frequency: 1 Reset counter: 57 Mileage: 142022 km Date: 2022.05.26 Time: 12:06:47 Voltage terminal 30: 11.7 V Outside temperature: 34.5 °C Inside temperature: 43.9 °C Right temperature flap: actual value: 0.0 % Right temperature flap: actual value: 15 Temperature door right - Specified value: 15 i have this one , do you mean that is the same motor flap ? (try to calibrate but same error show)
![ตีสิบเดย์ [FULL] | ครอบครัวสะท้านทุ่ง "นางบี & อ้ายสติ๊ก"](http://i.ytimg.com/vi/A1rhYcxxNtA/mqdefault.jpg)
This guy deserves a cameraman.
The restrictor broke what stops the gear from spinning itself out. put it back and works good 👍🏼 thanks for the vid
did you use a TORX t20?
How did you change the key? Mine can't turn, it' s impossible! Thanks
Very good! Thank you
i have clima manual no bizone and missing white flap on on right side below . it is normal? moreover when switch on high temperature i have only warn air on left side while on right not ,it is seems tepid what happen????
Zdravim prosim o radu mam golf 7 rv.2103 a chladi len ľavá strana pravá fuka teply vzduch mize to biť tento diel vadný? Ďakujem
Can you make a video how to change air distribution flap control motor V428 on vw golf 7?
Thanks for the video. I did a similar but simpler fix to get mine working again. MUCH quicker than removing and reinstalling the motor
1. The location of the motor is up under the glovebox. My car had a foam flap with a single holding screw which had to be removed first before what you can see in the video is apparent
2. The issue was the teeth on the gears had jumped (due to a stone in the flap), so like in the video the motor could not turn fully
3. Set the car temperature to full hot or full cold
3. A simple fix - pull the gear that drives the flap out just 2mm so the teeth no longer engage.
4. Then rotate the gear so the flap matches the motor either full hot or full cold. (The spindle will keep it locked to the flaps when you rotate it)
5. Push the gear back in so it re-engages with the teeth and clicks into place
6. Re-calibrate the heating and cooling. Now when you adjust the car temperature, the gear and the motor should rotate through the full range of motion and not get stuck
Much quicker and easier than this video
I don't understand how it would be easier.
If the motor shown in the video is broken how would messing with a thing under the glove box fix it?
I have a gear that pops out from the motor.
I will re-install it again but wondering what can be the cause.
You have mentioned a stone blocking the flap.
Any information for the driver side mine was clicking and the plastic end was on my footwell
Hi there, nice video but i was wondering, i took out the one u took out from the car, i put the connector back in to ser if it goes around, it did. But the car is still blowing cold from the passenger side.
Would appreciate feedback on that, what else could it be?
Thank you!
Does it cause a cold air always blowing on windshield
thanks for the video
I am trying to find where is located this part in Audi A3 2002 BFQ. If u know let me know plz.
Спасибо!
I have this error: "329220 Fault in motor for air distribution flap
B109D 71 [009]. actuator stuck" it could be the same piece to change ?
Hi. I have a 2016 Golf Mk7 GTD - I have noticed that the heater doesn't blow cold or hot air in the footwells. Any ideas how I could resolve this? Appreciate any help... Thanks
It’s most likely the same things. I have an audi a3 and have the same issue. there’s another motor on the other side. It’s more complicated to replace and believe that’s the one for the footwells.
Ahoj potřeboval bych poradit. Mám vw passat b8. A do zadu vůbec netopi čím to?
I have the same problem. 3-zone climatronic. According to diagnostics, it is B108E71- rear flap V137. Does anyone know how to get to that flap?🙏
Ahoj. Nefunguje mi kurenie, podla PC je chyba v module. Ale ked som vyzualne kontroloval tak pekne zasadne polmesiacik do zarezu a klapka ide na hot a takisto spät na cold. Ked dam ma max teplotu tak ide jemne teply vzduch...
možno je zapchaty radiator
Did he change The motor or only out and in Again
Jesus. I'm tiny and can't even imagine being able to maneuver this.
zdravim mám ten istý problém odkiaľ ste vedeli by ste sa nato pozrieť ? dakujem
Hallo ich habe fast dasselbe Problem ich habe einen Golf 7 kombi bj 2016 mein Problem ist ich bekomme links und rechts kalte luft also die Klimaanlage funktioniert aber in der Mitte kommt keine Luft mir sagte man dass der stellmotor defekt sein ist dass der selbe Fall wie im Video und wie lange dauert es uns was würde es kosten in der Werkstatt vielen Dank
Does anyone know a video showing the replacement on the left (driver) side?
th-cam.com/video/2ZQ0Hau3VcE/w-d-xo.html
no because nobody can do that. Too difficult 😂 I read about it in forums. You have to remove an airbag to reach the flap motor.
@@SunnyFLBoy It's tricky but can still be done using only a 5.5mm open ended spanner to remove the mounting screws. No need to remove knee airbag.
Another one here, in English th-cam.com/video/sx_vP7-t_oY/w-d-xo.html
Mine on a vw golf 16 plate and i cant see it either side ideas anyone? 16tdi dpf model
cool
Tiguan 2018, same work?
2018 maybe very similar
😊😊😊
Whats the part number for the motor/control unit? thanks
to najstavenie studenej pozicie sa neda urobit aspon v mojom pripade nie, dolezite bolo to dajako nasmerovat aby ten stredny vystupok zapadol do tej bielej medzery co otvara klapky , takze podla navodu sa neda postupovat uplne
this for flap flow right side only? there is another one on left side ?
Yes there's another one on the left side, it's black and has almost the same part number, the last letter is H
Mine doesn’t even have a module there.
I looked and mine doesnt either. I dont have the dual climate control so I think that is why. I do have the driver side module though.
I replaced mine I’m still not getting hot air ?
@@TheTriumphGuy101 I’ll mention that too my guy this weekend thanks for the tips
Thank you for this clear video! 👍
It was very helpful. I found that white gear wheel on the ground in front of the passengers seat and the right dashboard ventilation grill would only stream hot air. I placed the wheel back and now it's solved. I hope it will stay in it's place.
328197 - Motor for Right Temperature Flap
B108D 54 [009] - Missing Calibration / Basic Setting
Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 1
Reset counter: 57
Mileage: 142022 km
Date: 2022.05.26
Time: 12:06:47
Voltage terminal 30: 11.7 V
Outside temperature: 34.5 °C
Inside temperature: 43.9 °C
Right temperature flap: actual value: 0.0 %
Right temperature flap: actual value: 15
Temperature door right - Specified value: 15
i have this one , do you mean that is the same motor flap ? (try to calibrate but same error show)
Change only RF-370CB-10750 and put your back
you've tried? it worked? @icko
I have the same problem
@@salvo_san Hi mate, still not but probably for next 2 weeks will do , will let you know
Job is done , right motor flap not work properly replace with 2nd hand, calibrated normally, 45min work at all . OEM : 5Q0 907 511 L . Good Luck
@@MrIckov Now with second hand motor calibration is ok ? Climatronic works in heat?
Thank you