That new jaws feeling 🤙 but when finishing OD of the jaws its best to have them clamped on something dam close to the extended distance. You can damage the chuck footings other wise
Not really. You can do finishing to tight tolerances holding like this, and the concentricity & roundness will be good especially if you turn the chuck pressure down. I've made loads of parts for pumps, hydraulics and motors using this method.
Sir maine apki video dekh k programmer bana. Apka smjhane ka tareeka mst h. Mai is time successful programmer hu thnks sir.❤
Nice setting sir,really wonderfull
That new jaws feeling 🤙 but when finishing OD of the jaws its best to have them clamped on something dam close to the extended distance. You can damage the chuck footings other wise
sir aap ki video dekh kar sara problem clear hoo jata hai ❤❤
This type process only used for roughing operation...not use in close tolerance job
Not really. You can do finishing to tight tolerances holding like this, and the concentricity & roundness will be good especially if you turn the chuck pressure down. I've made loads of parts for pumps, hydraulics and motors using this method.
Ring to pakada nhi jwa me😮
❤❤❤ nice video ❤❤❤
👍👍👍👍👍
Nice video
Jaws machined without preload? Well, it may cause accident, as poor part fit.
Sir kaha se ho workshop or training location please sir
Call 09910440210
Sir mai apki video dekh Raha hu #5 tak
Sir nice
❤️❤️💯💯
Очень плохо, нет базы до чистовой операции. Будет не соосно
Какой базы нет?все нормально он сделал. Единственное кулачки надо на кольце растачивать