ETSNZ: Configure Altivar Process and PC for Embedded Ethernet communication

Basic VSD and PC configuration guide to communicate over Modbus TCP/IP to an Altivar Process

[@emmanuellagunas9335]

nice video! thanks so much !

[@diegovideo82]

Can I use a PLC Siemena S7-1200 to Control de VFD via embedded Ethernet Port? I saw a video where it shows that the use of an external module VW3A3720 is mandatory. Why? Thank you.

[@sozuki1]

REALLY GREAT

[@yashjaiswal7176]

Really nice video sir.. Can you share something about atv process 980 regenerative vfd's

[@PhoneOCEAN]

Useful video...
But it is showing overheating fault.. as i moniter with my laptop

[@syedumarjunaid5499]

I can find com parameters-> embedded ethernet

[@olehmoski2531]

I have a problem connecting the PLC and altivar 630.
The connection is there, but I can't run and monitor the Frequency changer parameters through the PLC.. can u help?

[@Crushin_Libs]

How much faster would you say this is over the Schneider RS458 to USB cable? I'm noticing the USB method to be atrociously slow.

[@etsnz5485]

Hi Preston, I have found there to be a slight improvement in communication speed when communicating via Ethernet TCP, however, I believe the limiting factor is the refresh/scan rate of SoMove which cannot be adjusted. But Ethernet TCP is better for other reasons such as the obvious - no more usb to serial adaptor cable, also if you don't have SoMove on your PC you can access the VSD web server to change parameters and extract the configuration.

[@rullyaljiansah6656]

anyway, i want to ask for NST status? how to fix to RDY status? thks

[@pumppanel3100]

how setup DI 1-6