Great video! So the chip latch separates so it's just the pins? I was wondering if I could do this first, then if I wanted to switch to a hondata s300 later on. would I have to re-solder everything? Or can I just take the latching part off and plug in the Hondata?
l installed all parts (p29) but it didnt pass over 4000 rpm and my engine light didnt turn off so l cut jumper wire.now l use stock ecu.what can l do.Could you help bro
Great video! So the chip latch separates so it's just the pins? I was wondering if I could do this first, then if I wanted to switch to a hondata s300 later on. would I have to re-solder everything? Or can I just take the latching part off and plug in the Hondata?
I'm not 100% sure I believe s300 comes with it's own pins because it sits over the latching area.
What is the value of r67 resistor?
My chip burned from someone.launch control and shift light l have but l cant understanding it doesnt work
It's true that u have to cut j12 to get Datalog
Yea to enable fast speed logging
Hello, excelent video, i need help with ecu p06-a52, i take ond without transistor Q21, i need number, pls
I will check for you
@@DIYKAI ok, thanks
@@williamsdelacruz9814 01594 is the number i seen on mine
l installed all parts (p29) but it didnt pass over 4000 rpm and my engine light didnt turn off so l cut jumper wire.now l use stock ecu.what can l do.Could you help bro
Try to reburn the tune the ecu is in limp mode....usually a bad burn file or bad SST chip
@@DIYKAI you are a intellegent and polite man .Thanks so much brother.Loves for you
@@meditationlife9337 Your Welcome! Anytime
@@DIYKAI kit installed by me.You said me reburn bro.may be this problem from 28 pin legs problem.what do you think
May some legs dont sit the board but my friend check legs with a device all of them working