How To Calibrate a Stihl Chainsaw With M-Tronic 3.0
ฝัง
- เผยแพร่เมื่อ 26 ส.ค. 2024
- A short video describing how to calibrate, or reset, a Stihl chainsaw equipped with M-Tronic 3.0. A calibration should be preformed when parts have been replaced or if the chainsaw does not seem to perform at it's best.
#Chainsaw #Stihl
Every other instruction I've seen/read says to wait for the saw to drop from that high RPM before letting off throttle and turning off
You did it wrong. You're supposed to hold the throttle wide open until it drops off revs by itself.
This is the correct way to calibrate the M-Tronic version 3.0 There is a different calibration sequence for versions lower than 3.0
Very clear. Very well done and to the point. Thank you.
I am working with a MS 362C-M just purchased now in December 2020. The procedure shown in the video corresponds to the description in the manual. If used year round and adjustments are made for summer/winter operation, will calibration still be necessary with the change in temperatures? Thank you.
Having isssues with some v3 saws never hitting the “high rev” after the 30 second idle (always go 40sec)...
Is it the same for the 500i ?
Whay need calibtate ? What's happeend with carburator to need calibrate ?
One calibration for sumer When température increase 25 degré Celsius and one calibration for winter for température decrease to 0 degré Celsius no morte that
avoir video en francais
How do I know which version of m-tronic my saw has?
look on the chainbrake extrem right upper corner
The silver regulations sticker
Should the saw be cold or warm when doing calibration?
warm
Does Husqvarna have a similar way of calibrating?
No
Haw is make to from huqvarna
I’m so sick of this m-tronic BS. All my saws got stolen and had to replace with new technology and drives me nuts.
You did it wrong. You're supposed to hold the throttle wide open until it drops off revs by itself.