Where did you guys use 1” tek screws? my manual says to use them to mount the storage latch but they don’t seem to fit. And your video uses 3/4” screw nails instead (4:19)
For those wondering how to put the lower right cover with the wire: pull the wire from under and the top of it as close to the pole/stand thing, hold it in place and then slide the half down. Be a bit careful but firm and it WILL slide through
Yes. You are correct. This video is a summary of assembling the machine. When we are doing this activity really, we have to do some effort to assemble the machine.
Where did you guys use 1” tek screws? my manual says to use them to mount the storage latch but they don’t seem to fit. And your video uses 3/4” screw nails instead (4:19)
For those wondering how to put the lower right cover with the wire: pull the wire from under and the top of it as close to the pole/stand thing, hold it in place and then slide the half down. Be a bit careful but firm and it WILL slide through
Hey, I'm having this problem and I still can't figure it out, can you explain a bit more?
right bottom was hard to do. also did you have to do anything else to get the screen out of the demo mode?
I could not get the bottom right cover on because the wire was in the way. Is mine defective?
Same issue
Same for me :(
The cover is not necessary
WHAT IS THE HIGHEST INCLINE??
This was not that easy to assemble, right side top and bottom was confusing
Yes. You are correct. This video is a summary of assembling the machine. When we are doing this activity really, we have to do some effort to assemble the machine.
Same problem
@@nethanthelifejourney8489