Hello....I notice in the video you have the same thermostat housing as I do. I am having enormous difficulty removing the back 2 hoses with these stupid quick fit fittings. Have you any idea of how to remove them please ?. You would have thought that squeezing the white clips should release it...but I can not get it to release. One side is very awkward to access. Many thanks
Just below the sensor you removed, there is a hose connected to the thermostat housing. Do you know how to release that hose clip? Do you push or pull the gray plastic things?
My fans coming on as soon as the engines running im going to see if this cures it , my battery looks to be on the far right where yours looks like the middle is it still under the battery?
I know this is an old video, but i have a question, if anyone is able to help? I have a Peugeot Partner with a warning message reading "engine fault - repair needed" but there is no engine management light on and no fault codes in the system. My fan also runs on for several minutes after each journey, could this be a potential cause of that issue?
My friend, my car is a Peugeot 206, the temperature in it is very high and dangerous. I replaced the radiator, replaced the water pump, and replaced the compressor, which when hot water enters it stops it What should I do next to fix my car overheating please reply
I have a partially similar problem for my 508 2.2 gt. I have replaced all those except compressor and water pump, but I still have my car showing check engine sign when external temperature is high.
Is that the exact place to add dpf additive??I'm struggling to find the pressure/temperature sensor on me 63reg partner.Its gone into limp mode and I've bought k2 dpf spray to use.Much appreciate any valuable explanation.thanks
Most of the time temperature sensor okey but sensor wires wich attached to the sensor lose from the clip you can check that this is common fault in Peugeot/ citroen
I had the same Problem. Like 30min I was trying to fit that clip. untill I realise that the black isolator was not in place. Once I put the isolator in place everything was fitting well! But I have destryed the wiring connector, the plug, and now I can not find another one to replace it. If somebody know where to find the plug please tell me. I have a fiat scudo 2014
what a brilliant simple to follow video no bloody off putting music thank you
I just replaced the dpf pressure sensor under thid battery bracket and i didnt realised this coolant sensor is there too ... Thank you for your video
Super little video and one of the only ones to get close ups of the thermostat, just changed on my 2011 207 1.6 hdi
Por fin alguien que en verdad lo hace sin hablar
Hello....I notice in the video you have the same thermostat housing as I do. I am having enormous difficulty removing the back 2 hoses with these stupid quick fit fittings. Have you any idea of how to remove them please ?. You would have thought that squeezing the white clips should release it...but I can not get it to release. One side is very awkward to access. Many thanks
hi, in the Peugeot 3008 is it always under the battery? congratulations for the video
Thank you! The video is simple, direct and to the point. Very helpful, thanks!
Just below the sensor you removed, there is a hose connected to the thermostat housing. Do you know how to release that hose clip? Do you push or pull the gray plastic things?
Found out. It has to be pressed from both sides.
Hello there engine fan won't come on if i use a paperclip in this sensor connection should the fan come on if fans good ?
My fans coming on as soon as the engines running im going to see if this cures it , my battery looks to be on the far right where yours looks like the middle is it still under the battery?
It didn't work its leaking coolant everywhere today hope its a pipe and not the gasket
Same problem
I know this is an old video, but i have a question, if anyone is able to help?
I have a Peugeot Partner with a warning message reading "engine fault - repair needed" but there is no engine management light on and no fault codes in the system. My fan also runs on for several minutes after each journey, could this be a potential cause of that issue?
Hi,
I have problem as you have described.
Have you fixed your problem and how.
Thanks
My friend, my car is a Peugeot 206, the temperature in it is very high and dangerous. I replaced the radiator, replaced the water pump, and replaced the compressor, which when hot water enters it stops it What should I do next to fix my car overheating please reply
I have a partially similar problem for my 508 2.2 gt.
I have replaced all those except compressor and water pump, but I still have my car showing check engine sign when external temperature is high.
Is this applicable to a 68 plate Dispatch?
Would this cause P0421 fault code ?
Regards,
is it necessary to vent the system after replacement...?
No
@@guddupappu3582 its automatic vent..? Thanks👍👍
Thanks for your helpful video
Is that the exact place to add dpf additive??I'm struggling to find the pressure/temperature sensor on me 63reg partner.Its gone into limp mode and I've bought k2 dpf spray to use.Much appreciate any valuable explanation.thanks
You can see the location of temperature sensor on 0.33
On my berlingo the Fan turns on soon after starting and stays on continually after the Van's being turned off.
Could this be the repair?
Most of the time temperature sensor okey but sensor wires wich attached to the sensor lose from the clip you can check that this is common fault in Peugeot/ citroen
What the symptoms if the sensor problem, my 308 temp always low 70-80 degree bcos when on the AC, fan always run fullspeed
When i start the car fan run in full speed
Thanks, Good help
What car was this ?
Peugeot partnrer tepee
Hi Guddu Pappu
I have the same problem with my 2016 Peugeot partner tepee. Is your car of a similar age?
Thanks
My car is Peugeot 208 please help me
What is wrong with your car?
I can’t push that clip in for the life of me
I had the same Problem. Like 30min I was trying to fit that clip. untill I realise that the black isolator was not in place. Once I put the isolator in place everything was fitting well!
But I have destryed the wiring connector, the plug, and now I can not find another one to replace it. If somebody know where to find the plug please tell me. I have a fiat scudo 2014
What was ur symptom?
Mine is running normal temperature but suddenlyvgoes in red and after 4 sec back to normal
did you get this fixed? I have similar problem
@@derekmcgilvray91 there is a 2 step relay close to fan in engine Bay. When it was wet outside there was problems