Quick Chips: Restoring a sine plate, Part 8
ฝัง
- เผยแพร่เมื่อ 1 มี.ค. 2024
- In which we make careful measurements of the backlash in the Z axis of the Okamoto grinder. We are surprised, and then delighted by a solution from deep within the FANUC control.
Links for products/designs mentioned are at pfg.gg/links
Follow me on Instagram at "spencer_webb_nh".
("PFG Stones®" is a registered trademark of Kinetic Precision)
Algorithm engagement activated.
Again, thanks for recording this project. I have enjoyed it. Doink.
Doink!
Excellent!
Good luck!!!
If you hold the cancel and reset buttons at the same time it will clear the alarm when write enable is on!
Good stuff!
Glad you enjoyed it!
good job! 🤦♀
Is that an OSHA approved E-stop cover on the control?
OHSHIT Approved.
@@KPNH 😂
Interesting that the digital readout doesn’t compensate for backlash. Does the Fanuc not have linear scales for the dro, or does it rely on rotary encoder feedback for positioning data? My old Reid 618HYD grinder has 30 thou of backlash in the cross feed, I’m real tempted to replace the lead screw with a ballscrew when I fit a dro to the grinder.