Check out the most viewed videos on my channel: 😍 Clap switch circuit 👏 th-cam.com/video/0ZeVsRDpZTU/w-d-xo.htmlsi=tCz1kBi8CxQUP8ga Darkness sensor 🌚✨ th-cam.com/video/kePkWBJPhYU/w-d-xo.htmlsi=HXZe4xrQD43vrnDS Voltage level indicator 🔆 th-cam.com/video/MHp1QqaaNd0/w-d-xo.htmlsi=7WFuoeLT1JYZie-3 Fire Alarm Cicuit 🔥 th-cam.com/video/A98oM_p3Kco/w-d-xo.htmlsi=w92x_1L5cEaqsSdL Light sensor circuit 🌈 th-cam.com/video/7kEjupgOM2k/w-d-xo.htmlsi=wUiLZQYkGoaGPYMj
Those are pull-up resistors. They ensure that when the DIP switch is open (not pressed), the input pin connected to it reads a defined logic level (typically high). Without these resistors, the input pin would be floating, leading to unpredictable behavior or noise interference. They are also used for current limiting . When switch is pressed , current which is flowing from Vcc to GND will be limited In summary circuit wouldn’t work without them
@@animeeditzz1145 those gray jumper wires connect the rails of the breadboard together , since i have wire connections on the all 4 rails of the breadboard
Check out the most viewed videos on my channel: 😍
Clap switch circuit 👏
th-cam.com/video/0ZeVsRDpZTU/w-d-xo.htmlsi=tCz1kBi8CxQUP8ga
Darkness sensor 🌚✨
th-cam.com/video/kePkWBJPhYU/w-d-xo.htmlsi=HXZe4xrQD43vrnDS
Voltage level indicator 🔆
th-cam.com/video/MHp1QqaaNd0/w-d-xo.htmlsi=7WFuoeLT1JYZie-3
Fire Alarm Cicuit 🔥
th-cam.com/video/A98oM_p3Kco/w-d-xo.htmlsi=w92x_1L5cEaqsSdL
Light sensor circuit 🌈
th-cam.com/video/7kEjupgOM2k/w-d-xo.htmlsi=wUiLZQYkGoaGPYMj
It worked, thanks ❤
It worked thanks 👍
Components name
What happens when you put in binary values above9?
Will it work with out resistor i dont get why u used resistor there
Those are pull-up resistors. They ensure that when the DIP switch is open (not pressed), the input pin connected to it reads a defined logic level (typically high). Without these resistors, the input pin would be floating, leading to unpredictable behavior or noise interference.
They are also used for current limiting . When switch is pressed , current which is flowing from Vcc to GND will be limited
In summary circuit wouldn’t work without them
@@ElectroMinok man but in the right there are two grey wires what is there work??
@@animeeditzz1145 those gray jumper wires connect the rails of the breadboard together , since i have wire connections on the all 4 rails of the breadboard
@@ElectroMinhow much volt are u providing?
@@ElectroMinif we use 6 volt do we need resistors to connect on 7 segment?? Or it will work without it
is it an common anode display or is it a cathode one?
Common anode
For 6 isnt that b not 6?
Didn’t get your question , what do you mean by 6 ?