If you have a red flashing light on one side and it wont move and Recalibrate doesn't fix it... Check all plugs and wires are getting good connection (Especially the 5 wire sockets). If they are and it still don't move then it probly has a blown output fet on the side thats red. They're easy to change.. MAKE SURE BATTERY IS UNPLUGGED!! Measure the Mosfets, 6 on a heatsink per side(GDS)... Usually only 1 or 2 short... DMM to Diode, Neg on Center pin (Drain), Gate approx +1.5v, Source approx .5v. YST7575C crosses to RU6888R 68v 88a TO220 *** For this model Mainboard, one bank of Fets controls one side wheel drive. Do a continuity test to figure out what bank controls what side.. Each bank of Fets, are broken into pairs per thick wheel drive wire (YGB)..
My brand new hoverboard run time is around 25 minutes then it cut off power of board. At full charge it was around 41.5 V and after 25 minutes the battery voltage was only 37.8 V for cut off. Why is the voltage still so high and already there was a cut off the power? At wat voltage should the board switch off? Any suggestions?
The board powered up... but when you gave it power it was upside down, when power is applied it does a system check immediately and it went into fault due to all the sensors knowing it wasn't upright
The video is old,, and I can't do anything about it now :-/ ,, sorry, tons of comments to get to. It more of an "HI I read what you wrote to me" thing :-)
I have a hoverboard Skymaster 11 double wheels, the board turns on and after a while it stops working, I disconnect plug from batery to electronics. I take multimetr, and there is a shortcut on the electronics. I take schorcut plus with the minus in electronics plug, i take multimetr and i do not have schortcut , after connecting electronic devices it works again, what could be wrong?
If you have a constant PSU you can connect it up to the dc in connector and the bad component will get VERY hot, more than likely it will be those transistors tho :)
+My PlayHouse (Morten Hjorth) yeah i have one and I have watch many tutorials and on many fails people did Step off the front and The airboard drives over you
Hello my friend I desperately need guidance The Hoverboard turns off in a rough bump and the accelerator suddenly shuts off Sockets are sturdy Do you have an email to send me an electronic circuit photo thanks for your help
At 10:36 , I would like to mention that I've also discovered a similar damage to my capacitor. At that precise location that you pointed out. I tried replacing them but after about 5 minutes of plugging charger in. The capacitor burns up and creates a plume of smoke that doesn't smell too bad. Can you send an email to me or private message regarding this matter?
Hi I did only try this little go as you saw,, ahh lie, I did a even smaller one just before off cam,,, It is hard to get on it :-) Thank you for watching! :-)
do you have hi amp lo voltage power supply?i see some car battaryes. get the most powerfull one charge it to full and connect to thing. it will blow up short and you find out where it was ;)or try trace power track... but that's too boring right !?BTW you're in Denmark, right ? i will be at Copenhagen in few days and if you're nearby i might help ;)
it's not about blowing up. It's about finding a point of short-circuit. If you have IR camera same thing can be done with less spectacular "visual effects" If I remember right on eevblog channel Dave got video showing entire process.
Hi Well I do not know what to think,, it was fun when you got on it,, but that was hard,, but had I been 12,, I'd want one,,a fast one to!! Thank you for watching! :-)
Seems like you understand my TH-cam name. Since you say thingyee often. My YT name I just named it because I wanted to show some things on TH-cam lol/ some thingyees. been this name since 2008.
Hi I never saw it like that,, but now you saw it,, you are the Thingyee... :-) I just say it when I don't know what the thing is called! Thank you for watching! :-)
Hey man love ur vids but.... These are not hover boards!!!! IM SICK OF PEOPLE CALLING THEM HOVER BOARDS. They don't hover and there not even really boards.
Yes,,,, you are right,, but the other names for them are really bad,,,balancing Board,, just sound lame... "Poor man's segway" Is kind of fun,,, but no real reason ti insult all with one of these boards. Thank you for watching! :-)
![Hoverboard LED blinkt 5 mal [Defekt] 1€ Reparatur](/img/n.gif)
If you have a red flashing light on one side and it wont move and Recalibrate doesn't fix it... Check all plugs and wires are getting good connection (Especially the 5 wire sockets). If they are and it still don't move then it probly has a blown output fet on the side thats red. They're easy to change.. MAKE SURE BATTERY IS UNPLUGGED!! Measure the Mosfets, 6 on a heatsink per side(GDS)... Usually only 1 or 2 short... DMM to Diode, Neg on Center pin (Drain), Gate approx +1.5v, Source approx .5v. YST7575C crosses to RU6888R 68v 88a TO220 *** For this model Mainboard, one bank of Fets controls one side wheel drive. Do a continuity test to figure out what bank controls what side.. Each bank of Fets, are broken into pairs per thick wheel drive wire (YGB)..
Hi OldSkool 55F100
Thank You very much! glad you liked the video :-)
Thank you for watching! :-)
My brand new hoverboard run time is around 25 minutes then it cut off power of board. At full charge it was around 41.5 V and after 25 minutes the battery voltage was only 37.8 V for cut off. Why is the voltage still so high and already there was a cut off the power?
At wat voltage should the board switch off? Any suggestions?
Check if the cells is at the same voltages.
The board powered up... but when you gave it power it was upside down, when power is applied it does a system check immediately and it went into fault due to all the sensors knowing it wasn't upright
Hi Jared Glascock
Thank You very much! glad you liked the video :-)
Thank you for watching! :-)
@@MyPlayHouse oh hey thank you very much glad you liked my comment, thank you for reading and replying with nothing to do with my statement...lol 😂😂
The video is old,, and I can't do anything about it now :-/ ,, sorry, tons of comments to get to. It more of an "HI I read what you wrote to me" thing :-)
what is the name of the transistor for ligth hoverboad
Hi
Sorry I do not have the board here now.
Thank you for watching! :-)
I have a hoverboard Skymaster 11 double wheels, the board turns on and after a while it stops working, I disconnect plug from batery to electronics. I take multimetr, and there is a shortcut on the electronics. I take schorcut plus with the minus in electronics plug, i take multimetr and i do not have schortcut , after connecting electronic devices it works again, what could be wrong?
I never got this one working :-(
If you have a constant PSU you can connect it up to the dc in connector and the bad component will get VERY hot, more than likely it will be those transistors tho :)
Thanx,, I ordered new ones.
Hope they did not take anything else with them,,, in the grave...
Thank you for watching! :-)
always learning
Hi anthony marino
Thank You very much! glad you liked the video :-)
Thank you for watching! :-)
I stay away from these things. I do not have a good balance, so i probably gonna break my neck trying to move around.
Good luck with the repair.
Hi thanx
They are a bit fun and a bit dangerous :-)
Thank you for watching! :-)
I have the black one and it’s charger is rated for 42 volts
Hi Code Disease
Thank You very much! glad you liked the video :-)
Thank you for watching! :-)
I think that extra heavy duty transistors and not the plastic ones
Okay,,,
Time will show :-/
Thank you for watching! :-)
can you help me how to connect Arduino with hoover board wiring diagram and code for Arduino for speed control
Sorry,, I never even got this working :-(
ok try some other soft
Just ask Google for that wire diagram they got it
did you get your parts in yet?
Yes I do think I got them all now... I just need the time :-)
Thank you for watching! :-)
a tip is to always Step off the hoverboard backwards its The safest way
Thanx,, are you sure?
I did not play with it enough to get much experience.
Thank you for watching! :-)
+My PlayHouse (Morten Hjorth) yeah i have one and I have watch many tutorials and on many fails people did Step off the front and The airboard drives over you
Hi W1LL3 | Gaming and More
Killed by Hoverboard,,,dohh.
Thank you for watching! :-)
Hello my friend
I desperately need guidance
The Hoverboard turns off in a rough bump and the accelerator suddenly shuts off
Sockets are sturdy
Do you have an email to send me an electronic circuit photo
thanks for your help
Hi mehdi jamshidi
Sorry I am not the right person for this,, mine does also still not work.
Thank you for watching! :-)
At 10:36 , I would like to mention that I've also discovered a similar damage to my capacitor. At that precise location that you pointed out. I tried replacing them but after about 5 minutes of plugging charger in. The capacitor burns up and creates a plume of smoke that doesn't smell too bad. Can you send an email to me or private message regarding this matter?
Hi Alexander Chu
Thank You very much! glad you liked the video :-)
Thank you for watching! :-)
@@MyPlayHouse I need help with this. Are you available?
@@alexanderchu3 sorry,, I never got mine working :-(
I have the same blue one
Hi David Farah
Thank You very much! glad you liked the video :-)
Thank you for watching! :-)
Why you have ordered them from china? From farnell you could have them next day :) Delivery is only 5 eur
HI
Well I am not in any hurry,, and I think it kind of fun ordering things in China.
Thank you for watching! :-)
Who else is riding a hoverboard while watching?
Hi Code Disease
Thank You very much! glad you liked the video :-)
Thank you for watching! :-)
these are prone to catching fire and maybe even discontinued
Hi
I had them both sitting in my car a couple of days, and was hoping on a new car,, on that account,,,nothing happen :-/
Thank you for watching! :-)
Try to change the flux capacitor, it should work then again...
Hi
Do you think? luckely spares can be bouth ad amazon : amzn.to/1UolTlG
Thank you for watching! :-)
i must buy a hoverboard too :D it is really good thing :D
Hi
I did only try this little go as you saw,, ahh lie, I did a even smaller one just before off cam,,, It is hard to get on it :-)
Thank you for watching! :-)
do you have hi amp lo voltage power supply?i see some car battaryes. get the most powerfull one charge it to full and connect to thing. it will blow up short and you find out where it was ;)or try trace power track... but that's too boring right !?BTW you're in Denmark, right ? i will be at Copenhagen in few days and if you're nearby i might help ;)
HI
I am not a blow it up kind of guy :-)
I am afraid that I am not near Copenhagen,, it is like 3½ hours away.
Thank you for watching! :-)
it's not about blowing up. It's about finding a point of short-circuit. If you have IR camera same thing can be done with less spectacular "visual effects" If I remember right on eevblog channel Dave got video showing entire process.
The battery (B.M.S.) That is your problem..
hate them "hoverboards"!
they along with people using them needs to be "by fire be purged!"
other then that nice video :P
Hi
Well I do not know what to think,, it was fun when you got on it,, but that was hard,, but had I been 12,, I'd want one,,a fast one to!!
Thank you for watching! :-)
Can someone link me a server with 32 or more gb ram for $210 or less that ships to sweden and has harddrive/sas drives in it
Please keep comments,,,, related. this is about "hoverboard"
Thank you for watching! :-)
:'( R.I.P Chinese segboard/segway/hoverboard 2015-2016
HI
You do not give me much hope :-)
Thank you for watching! :-)
you put your on off button wires on wrong switch them
Hi ron me
Thank You very much! glad you liked the video :-)
Thank you for watching! :-)
Seems like you understand my TH-cam name. Since you say thingyee often. My YT name I just named it because I wanted to show some things on TH-cam lol/ some thingyees. been this name since 2008.
Hi
I never saw it like that,, but now you saw it,, you are the Thingyee... :-)
I just say it when I don't know what the thing is called!
Thank you for watching! :-)
yes I am the thingyee ahhaha free advertising :P
Hey man love ur vids but.... These are not hover boards!!!! IM SICK OF PEOPLE CALLING THEM HOVER BOARDS. They don't hover and there not even really boards.
Yes,,,, you are right,, but the other names for them are really bad,,,balancing Board,, just sound lame... "Poor man's segway" Is kind of fun,,, but no real reason ti insult all with one of these boards.
Thank you for watching! :-)
I've seen a lot of people call them "swegways"
Hi beaker15
Yes I see that,, did not know that one swegways,,, :-)
Thank you for watching! :-)
3rd comment woot
HI
Are you satisfied with that 3rd place!! well I am NOT,, you have to ame to do better. :-)
Thank you for watching! :-)
first
Hi
Yep you are the winner of this one! :-)
Thank you for watching! :-)