Marlin 1.1.0 RC8 vs. 1.1.8 vs. Klipper Speed Test

Marlin running on a Mega 2560 with a Ramps Board.
High Resolution Zylinder.
Print speed set to 100mm/s
Same G-Code file was used for all 3 test.
For Marlin the G-Code was located on the SD-Card
Klipper was running a higher acceleration, therefore its looking a bit more impressive.

[@Deneteus]

Why was there no print comparison?

[@yaVDRgda]

More of this! I have Klipper already installed, but my Hevo is not ready :(

[@jaimevaldez3058]

Klaus what board are you using?

[@vjekoorlandini6744]

I would like to see this test with same acceleration and speed settings in both firmware's.

[@vjekoorlandini6744]

@@KlausMichaelKMS Check this th-cam.com/video/Z6EuTW-IUJU/w-d-xo.html

[@stevesquaredink3884]

@@vjekoorlandini6744 sounds like a stepper is frying in the background

[@vjekoorlandini6744]

Stevesquaredink that's broken fan blade

[@DrR1pper]

@@vjekoorlandini6744 you can't compare this with the video you linked to. Klaus's small radius cylinder test has a higher frequency of velocity changes than the one you linked to.

[@Shoopadawhoopa]

@@vjekoorlandini6744 The video you linked shows a rectangular object. try again with high-resolution and round/curved shapes ;) You will experience stuttering.

[@jocmok2553]

i love klipper,

[@tylersutton2216]

wow

[@JanB12Bikes]

what??? wow

[@tylersutton2216]

ikr