Almost spilled my water once you showed that hole 😂 This type of content goes hard, if you can maybe do a tutorial on how to install headers since i heard the o2 sensor is iffy … Planning to pair my isr straight pipe with a gwr header in the future !
also I run a pop tune with the same set up, for the midpipe connector make sure you torque it like 80ft lbs LOL or else it will slowly seperate until its 2 pieces again
Sounds very nice !
Sounds NICE
underrated as hell my bro got content :)
Almost spilled my water once you showed that hole 😂
This type of content goes hard, if you can maybe do a tutorial on how to install headers since i heard the o2 sensor is iffy …
Planning to pair my isr straight pipe with a gwr header in the future !
I had to install a custom gasket for my Tomei to fit the GWR header. The Tomei is made for the factory midpipe with the O ring gasket
also I run a pop tune with the same set up, for the midpipe connector make sure you torque it like 80ft lbs LOL or else it will slowly seperate until its 2 pieces again
That’s why the tomei doesn’t sit flush with midpipe
how do you get those crackles is it tuned?
It’s tuned
@@Mryataawith what? Versatuner? I’m trying to research the best pop and bang tunes that also include a little more power for my nd2
@@itsmecolson3012 yes, versatuner by fab 9 and i think its the only pops and bangs out there
Raise your car dawg LOL sheeesh that is gnar gnar. Also the sound is slightly different than it would be since there is a leak.
That’s already raised 💀 i was lower before lol
😂 you don’t know top fuel get a Tesla nerd
Wanna add your exhaust that bad how many children you sa non3e