Mine needs replacing on my 2004 Sienna with 162K miles. Clunking began a few months ago but was mild and only seldom. Yesterday it was VERY loud when turning to the right and I noticed a strong pull to the passenger side until I turned the wheel left, then the pull was gone. As soon as I turned right again, same thing. Big clunk and pull to the right. Toyota wants $2500 to repair. I think that's excessive. I cannot do this myself so I must find another alternative.
I have a quote here for $1301 from an independent shop for complete replacement with tie rods, tie rod ends, new fluid and alignment. 3.2 hrs. labor it says. My '06 has 215,000 miles.
You make it look so easy. Would it be possible to take off the bolts that hold the sway bar if I don't have those right angle electric wrench and the car lift? Thanks
So I just installed a new steering rack, but I can't get the steering shaft to slide all the way on. I have about an inch to go, but no matter what I do, it won't slide down.
I don’t know why mines went out so quickly on 147000 miles normally racks last longer than that on Lexus there is a lot of play in the rack I have done a flush few years ago and it’s been top off with clean power steering fluid
What brand did you use , I’m currently looking at new cardone
Good job 👍
Mine needs replacing on my 2004 Sienna with 162K miles. Clunking began a few months ago but was mild and only seldom. Yesterday it was VERY loud when turning to the right and I noticed a strong pull to the passenger side until I turned the wheel left, then the pull was gone. As soon as I turned right again, same thing. Big clunk and pull to the right. Toyota wants $2500 to repair. I think that's excessive. I cannot do this myself so I must find another alternative.
I have a quote here for $1301 from an independent shop for complete replacement with tie rods, tie rod ends, new fluid and alignment. 3.2 hrs. labor it says. My '06 has 215,000 miles.
You make it look so easy. Would it be possible to take off the bolts that hold the sway bar if I don't have those right angle electric wrench and the car lift? Thanks
Yes
So I just installed a new steering rack, but I can't get the steering shaft to slide all the way on. I have about an inch to go, but no matter what I do, it won't slide down.
Make sure the joint isn’t getting stuck on the firewall due to angle
Fwd or all? Seen a vid some dude had the worst time getting it out. How long would this take? For a dyi'er also need an alignment correct?
Front wheel, it’s a very straight forward job maybe a hour or a little more for less experienced and yes Deff need an alignment
@@realslavmedia5792 were sway bar bushings a bitch to take off? I gets hit with some pb blaster a few times a week for a week no?
I don’t know why mines went out so quickly on 147000 miles normally racks last longer than that on Lexus there is a lot of play in the rack I have done a flush few years ago and it’s been top off with clean power steering fluid
What years are the same as this 06?
7:30 ripped axle boot
Buddy how to drain the system thanks
i think it has a petcock on the bottom of the rad!?
sr that I have to disconnect to change only the sprocket mounting bushings. thank you
STOP with the ANNOYING MUSIC!!