Symptoms of a Bad EVAP Vent Valve Solenoid and how Test if it Has Failed
ฝัง
- เผยแพร่เมื่อ 1 มิ.ย. 2024
- Common symptoms of a bad EVAP Canister Vent Valve Solenoid and how to troubleshoot a bad vent valve.
Why Does the Gas Pump Keeps Clicking Off Video
• Why Does the Gas Pump ...
What is the EVAP Canister Vent Valve?
The vent valve controls the flow of air into and out of the EVAP system. It is also used by the computer (ECM) to test the EVAP system for leaks.
Symptoms of a Bad EVAP Vent Valve Solenoid
⦁ Check Engine Light is on
⦁ Fuel Smell
⦁ Gas Pump Clicks Off When Fueling Up
⦁ Pressure in the Gas Tank
⦁ Failed Emissions Test
When the vent valve fails, it will become stuck open or closed.
How To Troubleshoot a Bad EVAP Vent Valve
⦁ Scan for OBDII Error Codes
⦁ Test Vent Valve is Opening and Shutting
⦁ Smoke Test
⦁ Check Wiring
⦁ Check for Clogged Ports Lines
OBDII Codes for a Bad EVAP Vent Valve
⦁ P0455 - Large leak in the EVAP system detected
⦁ P0449 - Evaporative Emission System Vent Valve/Solenoid Circuit
Components with Similar Symptoms
⦁ Wiring or Blown Fuse
⦁ Clogged Hoses
⦁ Clogged Charcoal Canister
www.backyardmechanic.org
By using the information in the video user assumes all risk of use.
By using this information user assumes all risk of use. - แนวปฏิบัติและการใช้ชีวิต
![[4K] TREASURE(트레저) “KING KONG” Band LIVE Concert 킹콩은 라이브를 찢어🦍 [it’s KPOP LIVE 잇츠라이브]](http://i.ytimg.com/vi/p8bLLOxPDD8/mqdefault.jpg)
Bro thank you so much I knew I purchased the right parts you gave me best information on TH-cam everyone don't explain it the way you do much respect from Jamaica 🙌🏽🇯🇲
Very informative 🙂 as I apparently need one of these replaced,and like to have a better understanding.
thanks for the video....I have an f150 that I can't put more then a gallon in without clicking off. Disconnect charcoal canister and it still happened. It definitely not opening to let pressure through. Needed a good symptom video to confirm my suspicion. Thanks.
My mechanic says I need this but I have a code for a very small leak and I have a bad o2 sensor, my question is, is my mechanic scamming me because I’ve seen most of these solenoids cause large leaks
I have a 03’ Dakota V6 3.9L. Code: P0441
Replaced the Gas Cap & Purge Valve. Should I replace the vent valve and/or the evap canister.
I have a 2003 ford focus 2.3 my engine light cam on sunday afternoon as soon as i started my engine and i got a po446 cont circuit code could this be a bad vent solenoid ? I has a slit second where I smelled raw fuel one time and every other time i fuel up it clicks as soon as i put the nozel in
Have a p0456 code on my 2010 hyundai sonata .mechanic says need to replace charcoal canister. I already paid to replace vent control value 2 days before. How do i know that is what's wrong?
will a bad purge solenoid cause the pump to kick off also
You rock 🪨
Got a PO0456 code. Evap vent valve seals ok with light pressure, but not with vacuum. Would that generate an code?
Is a neg 1 psi normal for a fuel tank?
What should be the values of an ohms and a volt test? Thx.
Does it effect your car from starting?
GREAT Fuc$&@% Video bro!!! Thank you so much!!🙏
Really like your straight to the point video. Nice job! Questions: What conditions should be in place such that the PCM will open the EVAP purge solenoid valve while the EVAP canister vent solenoid is opened? i.e. I would think at idle the purge solenoid valve would be closed. Conversely at some higher RPM, with other certain conditions the purge solenoid valve would be opened and its open duration measured via the oxygen sensors (sort and long term fuel trims). I cannot find the DETAILED operation of the EVAP purge solenoid valve as controlled by the PCM (over all the engine speeds and loads)? I would expect the EVAP canister vent solenoid to be open at all times and only closed for a leak test by the PCM. I would also expect the EVAP canister vent solenoid to be open when the engine is off and car parked.
It varies depending on the year and manufacture.
Here is an example for a Third-gen Chevrolet Camaro
..150 seconds have elapsed since the PCM entered closed loop.
..Coolant temperature is above 176 degrees F. (80 degrees C.).
..When the PCM is not enabling injector shut-off, such as on vehicles with traction control while one drive wheel is spinning.
..The idle contact switch in the IAC motor is open.
..Engine speed is above 1,100 rpm.
..The engine metal temperature sensor is not indicating excessive temperature.
..Low coolant level is not indicated.
@@HVAC_Mechanic Have 2004 Malibu Maxx 3.5L - summer conditions - Long Term Fuel Trims way negative (-25) on both banks - temp 180 - various RPM - coolant level to spec. When the PCM commands the EVAP purge solenoid to open, does the PCM also command the EVAP canister vent solenoid to close or open?
Could you also get P0456 code if the vent valve is bad?
Thank you for this information. Currently still have a P1457 code even after replacing the charcoal canister and solenoid valve. No one rents a smoke tester, and the repair shops qoutes for the smoke test are between $150-$300. There has to be a better dyi for this issue. Any suggestions?
Hand held pump and a cigar
How about diagnosis the opposite where the automatic shut off doesn't activate soon enough so that everytime you fill up a small amount of gas spills out before it shuts off.
Hi I have a 2003 Ford ranger 3.0 V6 my motor is running rough and when I stop and shoot down the motor I hear like a weasel on the back of the truck you think that's one way to know that the canister vent valve is bad?
My Honda (over half a million miles) makes some odd noises, right above the accelerator, once the ac is shut off. Is this normal?
Please help me if you can. We have a 2014 mini Cooper countryman after 150,000 miles. It has been a pain in our butts. There is a clicking sound when the car is cranked when we first noticed it we were out of town, and they said that it was afuel tank vent valve. Nothing to worry about they said, but now it’s making this clicking noise. We’re scared to drive it very rough idol. Please help if you can. Thank you.
P0442 could it be the canister? Small leak detected
I have a 2018 ram 1500. I’m told I have to replace the entire tank. No “check engine” light. No lights on the dash. Was told my service team they ran a diagnostic, which didn’t show anything.
can the Vapor Canister Purge Solenoid also cause the same problems/symptoms?
That is my question I have now. I just bought a vent valve for only 32 bucks, figured I'd start w the small thing first,.. guna install in the morning so hopefully this is it...
if you do a smoke test and smoke comes out the valve, its not necessarily bad because it is normally open until it gets a signal, correct?
Yes, this is true. I should have clarified this better. You can turn it off by adding power, usually with a scan tool, or be aware of its location and that smoke will come out of it.
I have a Mitsubishi eclipse 2007 gs and check engine light is on but it will go on and of but my code is p0431 need help
A P0431 code is usually a bad 02 sensor or catalytic converter. I made a video on this code, here is a link. th-cam.com/video/7Dm_G2dyCGw/w-d-xo.html
Another symptom you forgot was a ticking sound which sometimes sounds like a rod or valve knock