ฝัง
- เผยแพร่เมื่อ 16 มิ.ย. 2024
- Nzxt Flow H5 vs NZXT Flow H7:
In this video, I compare the nzxt flow H5 pc case to the nzxt flow H7 pc case.
I go over side panels, aesthetics, cable management, radiator and fan support, etc.
Follow me on IG: / rabryn_renegade
Ch 1: Side panel thumbscrews - 00:00
Ch 2: Case Aesthetics - 01:28
Ch 3: Case Fans - 02:10
Ch 4: Power Supply Vent - 02:35
Ch 5: Top Radiator/Fan Support - 03:15
Ch 6: H7 Top Dust Filter and positive air pressure- 05:05
Ch 7: motherboard standoffs and pci slot covers - 07:10
Ch 8: Cable management h5 - 09:06
Ch 9: Cable Management H7 - 09:35
Ch 10: front panel, dust filter, fans
Ch 11: front inputs - 14:28
Ch 12: final thoughts - 14:48
Watch my other NZXT H5 video here: • I build in the NZXT H5...
#nzxt - วิทยาศาสตร์และเทคโนโลยี
If you're on instagram, consider following me: instagram.com/renegade_rabryn
The reason there's a dust filter at the top is because, when the PC is turned off, and the radiator fans are not blowing air out, dust will fall on the filter protecting the radiator fans ;)
Not the reason at all. They'll get way more dust when moving dusty air that made it through the front intake.
Not really. Dust build up will just get blow off the top fans when the pc is turned on.
@@albatross580 Not the one that fell through the fans into the top of the GPU, etc.
@@Le_Sourpuss you’re gonna get dust buildup on top of the gpu regardless. I have an NZXT H7 Flow with fine filters in a super clean gaming room, and the top of the gpu still gets covered in a fine layer of dust. There’s really no way to stop dust from entering the case, no matter how clean the room is.
@@albatross580 That's true. However why make it even easier for the dust to get there? ;)
amazing video, helped me a lot - The music is little bit too sentimental but in general brilliant job!
Thank you, your video really helped me to decide. I'll go with H5, because I'm looking for a smaller tower with great air flow.
Much needed review, hopefully your channel grows rapidly!
I like the comparison, really clear, it helps a lot!
Here's a tip. Run a good air purifier in the same room as your pc. I opened my pc the other day after a few years. I closed it right back up. It didn't need to be cleaned at all. Not to mention better air for you to breathe.
Super appreciate the comparisons bro!!
Appreciate you watching and commenting!
The H7 front fan bracket is removable via 2 screws in the top on the outside front of the case.
I noticed this right after finishing cable management and was like well great to know afterwards😂
Thanks for the detailed comparison!
the very best review, thanks!. I already have the NZXT H5 Elite. Looking for the H7 Elite for a home server
Wow.. all day today, i've been thinking about getting the h5 flow or h7 flow. thanks for the info
both are awesome, id personally get the h7 for the extra room
thanks for the comparison man!
Thanks for watching!
You can but also the front out for the radiators on the H7
I believe the top filter on the H7 is to keep things 'dust free' if you mount intake fans blowing cool air straight down onto your hardware and then blow the air out thru a front mounted radiator and out the rather porous front panel. Current contemporary case designs pull in air from the front , pushing thru a radiator and sending all that hot air into the case and all over the hardware you're trying to cool. Kind of defeating the purpose. The H7 design looks like it would be much more efficient, only cold air in, and only hot air out, assuming I'm right about the reason for the top filter.
Bruh insta subscribe because this was exactly the video i was looking for
Thx!
just to clarify the exact specs on what fans/rads you can fit in the h7
front: 3 140mm fans (pretty rare I think), or 360mm rad
top: 3 120mm fans, or 360mm rad
rear: 1 140mm fan (also pretty uncommon)
having the 3 140mms in the front and 1 in the rear can significantly increase cooling performance/dB ratio, which is what sold me on the case over others personally.
Would you run the top fans as exhaust and front+back as intake?
@@MolleonOSRS front as intake, back and top as exhuast
@@Pecch so 3 intake and 4 exhaust?
Ah, the front is 140mm. That’s a good configuration :)
@@MolleonOSRS yes, the fact the intake fans are larger, and also that my top exhaust has to go through a radiator, i believe makes for a decent positive pressure system
I only needed the first 5 mins or so of this video to see how large they are but ended up watching the whole thing it was kinda therapeutic with the music going on in the back
Glad you liked it
@@Renegade_Rabryn ended up ordering the H5 Flow about 1 minute ago haha thanks for your help
I have a yeyian 2200 and I'm looking for something with better cable management and a smaller size, which of the two do you recommend H5 or H7?
Wish the H7 came with 3 fans in the front. A fan hub/controller would be nice.
The main gripe with the larger H7 is the 50% heavier weight. Carrying it around, if you travel often, college, etc, is an added hassle.
wtf lol
@@JamieReynolds89 The larger case is heavier, so it's a bigger hassle to move around and stuff if you travel. Does that make sense? Do you understand the words coming out of my mouth?
@@RubbingPotatoes If traveling is your concern. Consider buying a laptop instead Lol
Edit: Or go the gym and that 50% more weight will feel like nothing :D
@@el_teodoro I have a laptop but it's too powered down for my taste. I'm talking travel like seasonal for a student that goes to university, etc.
@@RubbingPotatoes Cases like this, that are not meant to move, i much prefer quality build over weight. Heavier often mean better structural stiffness, less wobbly thicker plates and metal in general. H5 use very thin cheap feeling metal chasis. Of all well known manufacturers from what i can see, NZXT is one of those that use very cheap metal in their midle tier chasis. Not that others are significally better, but they are. Their cases look good in shoots and design is top tier eye pleasing, but when you inspect in person, is clear material quality is poor.
Good luck getting 1000 subscribers. subscribed.
Thank you very much!
Weird they didn't open the bottom like they did with the h510 that bottom is with holes, where you put the psu
I have a 4000d airflow but if not I’d def get an h5 since I am only have a 240mm rad.
Thinking captive thumb screws are cheaper than pressure fittings?
You forgot to compare the size between them =(
I just got a H7 and got surprised how big it is.. i'm thinking about switching to an H5, but i can't find a size comparisson
H7 Flow HxWxD: 505mm x 230mm x 480mm/19.9” x 9.1” x 18.9”
H5 Flow HxWxD: 464mm x 227mm x 446mm/18.3” x 8.9” x 17.6”
The H5 flow is: 41mm or 1.6” shorter in height and its 34mm or 1.3” shorter in length
Would you say that the NZXT ones are currently a little bit higher quality than the Corsair 4/5000Ds, considering the vented PSU metal is sagging on the corsair?
I would say they're about the same quality. I prefer the design of the nzxts over the corsairs
With rhe smaller H5, can the top aio radiator mount block the tall ram ?
is the lower 120 intake on the h5 a pwm fan?
WTF is up with the sad background music XD
Yeah it's like sad creepy Silent Hill music lol
I just learned that there are RGB versions of these cases!
You should setup the camera fixed instead moving it around like that. Btw, thank you for the information and +1 sub.
Wow i need to see the vid of how u put a 280mm radiator cuz the 240mm scare me for my ryzen 7 5800x3D and rx 6800 xt
I have an h5flow and im getting an rx 7800 xt and idk if i should switch for the h7flow for lower temps of the cpu
What did you end up doing?
i dont know nothing about computers but my bf likes it so im watching it with him!!! great video very nice, they look pretty!
Why is the h7 flow glass side not printed?
I wanted to buy h7 flow,
but then i saw that its tinted so I don’t really want to buy it.
SO HOW???
very helpful video
Hi I would like to ask that the H5 at the top can it hold a 240mm radiator or no?
Yes
Please subscribe to help me reach 1000 subscribers. Thank you!
subbed
@@Zombie101 🙏
@@Renegade_Rabryn I actually liked the first person perspective that you filmed it in, like it wasn't trying to be all flashy and show sexy angles, it was useful cause it was like we were viewing it for ourselves at all its angles whilst covering off the practicalities, keep up the good work mate
5:25 A youtuber named Linus Tech Tips did a live stream of fixing pc and at the end he explains why it would be better to make the top intake instead of exhaust. (I'm not saying your wrong I'm just saying you can possibly find better cooling if you make the top intake as well.)
I wish NZXT didn't tint the side window. I prefer the clear windows.
Hello by any chance do you know if this case will support rx 7900 xt red Devil, I currently have Nzxt H510B case and my new GPU did not support it I was wondering if the H7 will be great
H7 supports up to 400mm gpu length. Your red devil is 338 so yes
@@Renegade_Rabryn thank you for replying it won’t be vertical mounting right because I also don’t like when the gpu is vertical
Why in Amazon they say h5 taller than h7 ?
Good case
H7 hands down is the best 👍
After I watch your video I become dizzy.......
Does the H5 have a front dust filter?
Yes
U need a better camera filming but the vid is good
H7 without a doubt is the better case
I agree
Heat rises so if you had intake fans at the top they would be fighting physics. Still could be beneficial regardless.
What you're referring to is natural convection, which is meaningless in an actively cooled box. So easy to overcome it's not even a fight.
H5 H7 H9 nzxt made the best case
Very detailed but please use a tripod 😢
great video
BRO THX. But you need a friend to hold a camera for you
perfect video.
more one subscribe
dude your breathing is giving me a hard time, nice review tho 👏
whats w the sad music lol
@6:30:sucking cold air from the outside through your radiator into the case? That makes absolutely no sense. The purpose of an AIO is to move hot air from the CPU block to the radiator and exhaust it outside of the case, not suck it back in so you heat up your case even more. I guess if your fit 3 140mm fans at the front running at 2400rpm and flip the rear fan at the back so in becomes an intake fan it might work. You would go deaf from the fan noise. No one does this and this case isn't set up to work that way.
sub+ :)))
Thanks!
These cases are sh*t..better to go for other brands..
H5 looks better in every department. Even the screws i like cause it gives a more secure closure. I don't get why you prefer it without them. If it is closed with magnets chances are that in some years the magnets might go wrong while with screws you are always safe.
There are no magnets. They are little balls that clip and unclip into little sockets
The panels don't have magnets. They have clips.
@@Renegade_Rabryn Ah. well clips may still malfunction at some point. A screw is for ever. It is strange that H5 looks to have also clips+screws. While the other seems to have only clips. That is strange. Anyway it is still a very nice case the H7. I just prefer the h5 myself
H7 is better, those screws look like trash and are more effort to use, also screws lose thread over time