I noticed Dji mavic mini body shell is really thin so if grab the drone body if I too hard hold and it can damage the drone body shell inside clip can be break or separate. Since DJi reduce the drone weight lots of lose weight from body shell so as you can see and feel body is thin and flimsy. Thanks for the great video!
Still, it´s a shell, but think of an egg, it´s thin too, but very strong. Also, trough the reduced weight and speed, it can´t destroy itself easily. If we step on it, for sure it will break, but who want´s to step on a ~800$ Drone? Have no fear, good flying!
Thanks for sharing the tips. I would like to stick a red reflective tape on the body and arms against birds attacks (tip from TH-cam) due to it can be made of some aluminum layer inside I would stick it in safe location. I spotted where the GPS module is, but where is a compass? Some people say it is located in front arm. Tape can interfere with compass and have no clue where it is. Where is it? Thx in advance
Hocam şimdi cihazın sensörlerinde problem var diye söktünüz iyi güzel hoş. Peki hata neredeydi? Asıl önemli olan şey o :) Nasıl düzelttiniz devamı gelecek mi :)
My drone motor is damaged and I want to replace it, can I solder to the previous wires and not touch the board? my drone is Dji mini 4 pro , Thank you for your guidance.🙏
I crashed my mini 4 pro, it was with rc2 and after crash the view was visible but after few minutes the drone got disconnected, and now after repairing the physical damages the drone is still not getting into pairing mode or it is not getting connected to the remote
Thanks! Can you disassembly RC-N2 controller as well? I need to mount cables for Alientech Duo II antenna and I don´t know, is it any differences inside vs. RC-N1? Can you disassembly antennas in Mini 4 pro drone too? is this visibke differences because extra 5.2 GHz?
Why are you wasting your time modding the RC-N2? Telemetry + control is short band - video is wide band. Shortband range is 2 or 3 times higher than wide band. Most people think when they loose video, they loose all connection which is not true. If you want higher range on video, you need to enhance the drone transmitter with an amplifier. Not the RC antenna.
My mini 4 crash on the tree after that the obstacle sensor seems not working right, no matter how far I am from anything is always beeping and showing close obstacle. Is there anyeway to recalibrate or something got broken? Thank you.
I’m having the same problem after a crash and vision assist display is blank. Does your drone’s tracking (master shot, quick shot, active track) feature work after the crash?
Normally an Air Compressor is sufficient, just blow the dust/sand out. The bearings are normally closed, so no dust should get inside the bearing. Still, be aware when using an Air Compressor (violently) you may blow Dirt inside or damage sensitive parts! Be gentle! If this doesn´t solve your problem: Look under the motor, normally there´s a C-Clip, after removing it, you can pull off the Bell.
I wasn't expecting the ESC board to be that small, interesting tech
Hello, How you mount back together plastic body covers - top and bottom, before screw them?
(as for unmount you used heat gun.)
uyuya kalmadan video yu bitirdi ohh dedim kendi kendime
Thank you so much!!!! You are a blessing🔝🔌🙏🏾
Kardeşim eline koluna sağlık kol değiştirmek için komple söküm gerekiyormu esc ye daha pratik ulaşma yolu yokmu
Realmente tengo que hacer eso para cambiar un solo brazo?
Reaching under the PTZ cable like that with your tweezers is a good way to royally $&@#% up the pins 😂
Merhabalar Djı mini 4 pro için sol arka ayak kabuk kırılımı yaşadım yardımcı olur musunuz ?
Are the sockets into which the screws holding the arm spring are screwed in, plastic or metal?
I noticed Dji mavic mini body shell is really thin so if grab the drone body if I too hard hold and it can damage the drone body shell inside clip can be break or separate. Since DJi reduce the drone weight lots of lose weight from body shell so as you can see and feel body is thin and flimsy.
Thanks for the great video!
Still, it´s a shell, but think of an egg, it´s thin too, but very strong.
Also, trough the reduced weight and speed, it can´t destroy itself easily. If we step on it, for sure it will break, but who want´s to step on a ~800$ Drone?
Have no fear, good flying!
Hello, thank you for your useful video😘
Mini 3 pro kiti mini 4 proya oluyormu bataryası
merhaba merak ettim.bu dronun akibeti ne oldu şuanda hayatta mı yoksa kimsesizler mezarlığında mı :)
hi. i got sand in my motors and now are stuck. how do you clean it? thanks!
it would have been nice to show what size drivers are necessary 😕
Hello I recently bought this drone but its part that you removed first the heating gun it is little bit up
Thanks
How much does top and bottom shell weigh? Id like to remove them to add prop guards and still be under 250g ...maybe? Anyone try it?
Why the heat ? Is that really necessary ?
Thanks for sharing the tips. I would like to stick a red reflective tape on the body and arms against birds attacks (tip from TH-cam)
due to it can be made of some aluminum layer inside I would stick it in safe location.
I spotted where the GPS module is, but where is a compass? Some people say it is located in front arm. Tape can interfere with compass and have no clue where it is. Where is it? Thx in advance
Hocam şimdi cihazın sensörlerinde problem var diye söktünüz iyi güzel hoş. Peki hata neredeydi? Asıl önemli olan şey o :) Nasıl düzelttiniz devamı gelecek mi :)
Yeterli like ve izlenme sayısı gelirse devamı tabiki gelir. İlk önce motive olmamız lazım :)
sen destek iste yeter ki 3-4 hesaptan takip ettim beğendim :D @@Djiservisi
Teşekkür ederiz 😂😂
My drone motor is damaged and I want to replace it, can I solder to the previous wires and not touch the board? my drone is Dji mini 4 pro , Thank you for your guidance.🙏
I crashed my mini 4 pro, it was with rc2 and after crash the view was visible but after few minutes the drone got disconnected, and now after repairing the physical damages the drone is still not getting into pairing mode or it is not getting connected to the remote
Merhaba,iki gün önce kurulum yaptım fakat saat ayarında atina yunanistan bir saat geriydi diye moskova seçtim..bunu nasıl değiştirebilirim..
i love your videos, is there any way to connect you?
Hi dear thank you
+905461200705 WhatsApp
Thanks! Can you disassembly RC-N2 controller as well? I need to mount cables for Alientech Duo II antenna and I don´t know, is it any differences inside vs. RC-N1? Can you disassembly antennas in Mini 4 pro drone too? is this visibke differences because extra 5.2 GHz?
Why are you wasting your time modding the RC-N2? Telemetry + control is short band - video is wide band. Shortband range is 2 or 3 times higher than wide band. Most people think when they loose video, they loose all connection which is not true. If you want higher range on video, you need to enhance the drone transmitter with an amplifier. Not the RC antenna.
My mini 4 crash on the tree after that the obstacle sensor seems not working right, no matter how far I am from anything is always beeping and showing close obstacle. Is there anyeway to recalibrate or something got broken? Thank you.
I’m having the same problem after a crash and vision assist display is blank. Does your drone’s tracking (master shot, quick shot, active track) feature work after the crash?
how to open the propeller motor, to clean the dust inside?
Normally an Air Compressor is sufficient, just blow the dust/sand out. The bearings are normally closed, so no dust should get inside the bearing. Still, be aware when using an Air Compressor (violently) you may blow Dirt inside or damage sensitive parts! Be gentle!
If this doesn´t solve your problem:
Look under the motor, normally there´s a C-Clip, after removing it, you can pull off the Bell.
Camera Lens Error 1C000310 please tell me how to fix it
Merhaba djı mini 4 ön menteşe stoklarınızda mevcut mu
malesef şuan yok
bu yapılan işin maliyeti ne kadar
Where can I buy the mini 4 pro camera?
dji service in your city
merhaba sizden bi sorun icin arayabilirmiyim whatssptan