2001 Mercedes Benz E430 TPS

[@ryancarriveau]

Thank you for making this video. Just replaced the TPS on my 01 E320 that was occasionally stalling (especially after a hard acceleration)

[@fahadalbaradan7061]

Excuse me brother. I have E 320 .. the RPM indicator cant be increase during stopping case . Is it the same problem (tps)

[@ryancarriveau]

@@fahadalbaradan7061 sounds like a different problem

[@mvernon1979]

Update. I can now fully accelerate and not have the car go onto limp mode. Still have the abs,brake,esp light come on while driving so I will be looking into that at a later time.

[@TWINJO20]

You might know this but, if you turn your steering wheel all the way to the left then to the right, you will probably reset the abs,brake,esp light.

[@ataahuamamasita8463]

I will try this

[@ronaldewing8677]

I replaced mine too but after 2 weeks it started hesitating again and making a whistling sound do I have to tighten the top part of it

[@ronaldewing8677]

I had the same problem I bought a sensor it worked for about a month and started doing it again hesitating Could it be my sencer was crap or do I need to reset by turning that thing by the coil

[@ronaldewing8677]

My ABS is on to mechanic told me I can either fix it or not my break still works I don't need ABS so I don't fix it

[@rubengarcia7238]

I found it easier to take the sensor bracket off entirely by removing the two 10mm nuts and then the screws and then reversing the process once the sensor has been swapped since that'll spring can be uncooperative

[@mr.b8489]

Thank you for your help

[@yquest3642]

I have an issue as well would this bring up codes that may be coil pack issues but really is this sensor. I put my foot to the floor and no

[@caremotor86]

I am about to replace mine kinda intimidated by that stupid spring that needs to be place right

[@ryancarriveau]

I was nervous about the spring too but I took a quick video to see where each end of the spring goes and then it wasn't bad.