Soldering station flask repair

If you like the content I publish, you can support the channel. Thank you
tipply.pl/u/sz...
PayPal [e-mail]
Thank you to anonymous and named people for supporting the channel 😁
Links to materials used in the video:
By using affiliate links you support the channel, thank you.
Microphone 🎙️ SYNCO G1 alii.pub/6mq47k
In this episode I will diagnose and repair a soldering iron iron. I was going to do it a long time ago, but there was no time, opportunity or desire 😜
As always, it's worth measuring and checking before you start cutting. Fortunately, I wasn't in a hurry and measured everything before making a mistake. It turned out that the solders holding the heater and thermocouple were the cause of the failure. All I had to do was correct the solder and everything worked like new, apparently I overheated the stock once and that resulted in the degradation of the tin. Fortunately, we didn't have to buy anything extra, just replace the tin and that's it 💪
Timeline:
0:00 - 1:22 Introduction to the purpose of the episode
1:23 - 3:35 Taking apart the soldering iron
3:36 - 7:17 Desoldering the wires
7:18 - 9:04 Measuring the tubes of the stock
9:05 - 11:06 Test after repair
Current episode made with:
Synco - G1L - microphone
iPhone 8 - Audio and video
Assembly - iPad 9
Thank you very much @Kenny88 for creating a trailer for my channel 💪

[@MaoWatt]

Bardzo ładnie, nie wybuchło 🙂

[@SzymonHawlicki]

Udało się, dużo nie brakowało a bym zbytecznie skrócił ten kabel 🤣

[@MaoWatt]

@@SzymonHawlicki tak wyglądało jak uszkodzony kabel, jak widać nie zawsze jest tak się wydaje 😅 ważne że działa😀

[@SzymonHawlicki]

@MaoWatt leżało to chyba z 2 lata bo się ostro zdenerwowałem że stacja użyta kilka razy a już się popsuło. Jak widać „co nagle to po diable” 🤣