Orifice TAPPING Types and selection | When to use what guide.

[@AsadPassionateEngineer]

🔴Thanks for watching and if you have liked the Video then you can check out my Master Class on 👉 UDEMY
I am highly positive that you would find the Master Class super valuable.
Link to Udemy Masterclass : www.udemy.com/course/how-to-read-pids-piping-instrumentation-diagrams-symbols/?couponCode=LOWESTPRICE389
Keep learning and keep growing in your career !!! ✔

[@mdnzm31]

short and sweet , easy to remember,ur videos r Amazing

[@AsadPassionateEngineer]

Thank you so much for your kind words of appreciation it means a lot !!!

[@SwatiKeni-f5j]

Can u make a video on the angles of tapping 45 degree down wards or 3 or 6 clock position which should be used

[@shefalipaul4263]

Thanks for sharing valuable information about orifice.

[@cdiwakareie]

Really worth for all i&c people. Kudos

[@AsadPassionateEngineer]

Thank you so much for these kind words of appreciation!!! They really mean a lot to me !!! thanks Chandrababu Diwakar 😊

[@buhimanshu]

I am highly impressed by your knowledge content...keep enlighten us.

[@AsadPassionateEngineer]

So nice of you, thank you for your encouragement and support 😊

[@uniquesakshi10]

Very well explained.Thanks.

[@AsadPassionateEngineer]

Glad it was helpful! 😊

[@Worldfamousvlog1996]

PIP standard ki book download ka option nahi dikha raha ?

[@chinmaycmp]

Would you please share brief on installation guidelines (straight run requirement) for various flowmeters... Or any standard to be referred?
There is bit confusion as each Vendor suggest different lengths.

[@AsadPassionateEngineer]

For Straight length requirement ISO 5167 is one of the most widely used standards, this standard could be helpful and yes i am planning for a video that cover straight run calculation of orifice flow meter 😊

[@harshilshah4641]

Please upload complex type Interface level measurements and pump operation from PLC.

[@AsadPassionateEngineer]

Noted..... I am working on those in background, hoping to release them soon 😊

[@omkarpawar9178]

Amazing 🤟

[@AsadPassionateEngineer]

Glad you liked it! 😊 thank you so much for the appreciation

[@abhishekmurarka1984]

Nice video

[@AsadPassionateEngineer]

Thank you so much Abhishek !!

[@ankurbhatnagar3241]

Good

[@AsadPassionateEngineer]

Thank you for your continuous motivation .... It really means a lot Ankur 😊

[@okkomp]

Tapping or taping

[@abdessamedghettas7167]

Thanks

[@AsadPassionateEngineer]

Most welcome 😊

[@samikatnet]

No exact details provided about Radius and Pipe tappings. Tapping location and for which size of pipe to be used not mentioned