Factory s10 rear end The bed is raised with new factory tubs. You can see that in part 2 of this build. Tires are between 10&12 inches wide. I would have to remeasure that it’s been a while now.
What did you guys do so the driveshaft don't hit the cab? And did you cut the cab mounts to a shorter? Thank you I'm stuck in that part lol I was thinking of just lifting the cab a little so it clears driveshaft
In part 3 of this series addressed the driveshaft. We didn’t have a clearance issue but it was very close. I probably had my engine and trans mounted low enough
It’s just an aftermarket booster and master kid from speedway performance. Plumbed into the factory s10 proportioning valve. I would have to look up The part number
If the wheelbase on my 59 Apache is 121”, & the s10 frame on FB Marketplace is 123” ish, would this work? Looking online it says factory wheelbase for 59 apache is actually 123”, although i measured from center wheel to center wheel. Please help a youngster out!
Yes it will work just fine. One way to increase or decrease wheel base is to move the rear axle rearward or forward on the leaf spring with offset spacers. Or drill an offset line up hole in the axle perch
Cool swap...I just wished I'd seen more of the fabrication process.
Go to the 50 gmc to s10 swap
More details there
Most recent swap
Looking good!
Nice truck amigos
Amazing!
What rear end are you using? Are you going to have to tub the bed? How wide are those rear tires?
Factory s10 rear end
The bed is raised with new factory tubs. You can see that in part 2 of this build.
Tires are between 10&12 inches wide. I would have to remeasure that it’s been a while now.
Lots of fun
What did you guys do so the driveshaft don't hit the cab? And did you cut the cab mounts to a shorter? Thank you I'm stuck in that part lol I was thinking of just lifting the cab a little so it clears driveshaft
In part 3 of this series addressed the driveshaft.
We didn’t have a clearance issue but it was very close. I probably had my engine and trans mounted low enough
I didn't hear you mention what the brake booster was from and the master cylinder.?
It’s just an aftermarket booster and master kid from speedway performance. Plumbed into the factory s10 proportioning valve. I would have to look up
The part number
If the wheelbase on my 59 Apache is 121”, & the s10 frame on FB Marketplace is 123” ish, would this work?
Looking online it says factory wheelbase for 59 apache is actually 123”, although i measured from center wheel to center wheel. Please help a youngster out!
Yes it will work just fine. One way to increase or decrease wheel base is to move the rear axle rearward or forward on the leaf spring with offset spacers. Or drill an offset line up hole in the axle perch
How does the titling go? What counts? The old truck title or the s10 title?
Titled as what you see in NC
50 Chevy
i have a 56 pickup im planning on doing this. Is that a short bed single cab frame?
Single cab LONG bed.
118 inch wheelbase
@@gordonsmart @ amigo, what’s the difference on width?? Between s10 & stock chevy?
@@gerardolopez5875 the s10 is more narrow. I will have to measure to be precise. I’ll send you that info next week when I get to the shop…
@@gordonsmart @ do u had to use spacers??
@@gordonsmart @ how to know were to locate the cab mount support?? I mean the height, from s10 frame,, There’s any reference point
Short or long s10 frame
Long bed single cab