NEW DRX2 drive motor dissasembly. Loctite is our friend!

Showing why you should take apart your brand new dozer.

[@awesomusmaximus3766]

All the bolts were loose on mine too it was lucky I chose not to drive it till I installed the light kit

[@thatsmyrc]

Did you get a good deal on this dozer? I had torn mine all down before first drive, and rework almost everything inside that hub. I foreseen metal on metal continuing pressure contact also those screws you mentioned as one of the other issues. I had sanded outer hub down to narrow the depth of hub so the rear Oring will set freely and not squeeze out or be so overly tight with pressure. also I had used a demmel to rework the inner diameter depth of hub front plate where the 4 screws&p ring washer ride. This keeps the floating outer hub in which is sets to ride up on the secured ring and wear the bejesus out of it sending metal shavings non stop into your planetary gears. I have seen multiple breakdowns on these hubs and when shown in videos they all seem to have the marking of the issues I have tried to eliminate. So far so good with mine not a whole lot of drive time on it, but I will still get the brushless upgrade new designed system when they are up on market.

[@heavyrc8560]

Yes I cant seem to remember that it's DXR2 rather than DRX2 🤦‍♂️

[@heavyrc8560]

Doh!!! good catch.