RD350LC Engine assembly part 2

Second part of the Yamaha RD350LC engine assembly.
Music:
Sunspots by Jeremy Blake
Stranger Danger by Francis Preve
We could reach by Freedom Trail Studio
Slow times over here by Midnight North

[@chadpieterse3703]

U are my hero I striped my tamaha RD 350lc engin 11 years ago I was 16 now im rebuilding it thank you sir you are the best. slow step by step I highly appreciate it 12 out of 10 Thank you

[@samronjude]

Great work 👌

[@jh-tech5546]

Thanks!

[@sasikumarbakkiriswamy4290]

Very clean WORK very good video thank.

[@travelladdict5138]

Good work and im ready to share your neat work and full support for your channel from my side

[@quintonh8026]

Very cool. Thanks for the share.

[@jh-tech5546]

Thank you!

[@dpledger122]

great work

[@jh-tech5546]

Thank you!

[@vikramejames]

Will be wonderful if you share the torque values for the case bolts, head bolts, clutch nut etc. Thanks in advance, great video and lovely way of working!

[@jh-tech5546]

Thanks for your comment. That would be nice indeed. I will think about it when editing a next project. Sorry for the late reply.

[@grahamlangston2101]

The pillows that the 6 bolts go into brake off easily don't over tighten

[@jh-tech5546]

That's right.

[@wandeeir9683]

the iron plate. sharp edge should face to inside or outside?

[@jh-tech5546]

I assume you mean the plate that holds the bearing of the main shaft in place. That is rounded edge outwards, sharp edge inwards. At least that is how I mount these.

[@Pianissimo1970]

The clutch basket seemed dry, didn't you oil it before putting it on the axis

[@hermannkupper7180]

Perfekt job💪

[@robertosansoni4421]

I have ruined the screws with the cross head you put at the beginning of the video, can I replace them with hexagonal head bolts or have the screws been put in for a specific reason?
You have a table / link where to see the tightening of the engine bolts, thanks.