Rheingold ISTA - BMW How to read DDE measured values
ฝัง
- เผยแพร่เมื่อ 9 ก.ย. 2024
- BMW Diagnostics with ISTA - How to read out DDE measured values (air mass system, reail pressure, general values), with ISTA D.
The information contained on this video are for educational and informational purposes only.
We accept no liability for incidental or consequential damages and assume no responsibility or liability for any damage suffered, as a result of the use or misuse of any of the information or content on this video.
Dont show pressure before high pressure pump, so i cant figure out which pump is bad
Very good information!
Been troubleshooting a low rail pressure , no start fault, with ista. Seems like the HPFP is mechanical since it only tests when cranking or running. Can you check what your rail pressure is at stand still . I want to compare. mine ranges from 0 to 2. When cranking only gets up to 35, should be >250. I have a filter and sensor coming.
Sorry for replying so much later to this comment. Did you ever fix this issue? Im haveing the same problems with rail pressure only getting up to 40ish
@@Louis-md7es mine was hpfp. Warranty covered.
@@Louis-md7es mine ended up being the HPFP iirc.
what was the car? do you remember? I wanted to compare the values with mine. minimum what would help me is what's the engine. if I'm correct the car was X1 it seems from the video. so the engine was N47, right? or was it something else?
why don't I have the "read measured values" box?
Same.
same problem here. Did you find it?
Hy I don't gave the " read measured value option" can You help me?
thank you !
Wow! It loads so fast.. 1 minute only. Mine takes a few minutes
What means DDE?
Digital Diesel Electronics
Дружище у тебя со звуком есть ?
Przeciez masz reingolda po rusku