Quick question on the 2000 Sea-Doo bombardier and 951 is there a oil dipstick on this jet ski I cannot find one to save my life I always work on four wheelers I never work on jet skis at all please somebody I need help
Hey Good Timen Tools, I have a question, I have a 2002 Seadoo Bombardier GTX DI, and when I put it in the water runs like a minute and dies, wait couple of minutes and starts again runs for a minute and dies again, I can find what the problems is.! any Advise I will appreciate.
Well..... These things are a royal pain the the a$$. Im still fighting with chasing issues with this one. In your case, if you can run a remote fuel pressure guage to check if your maintaining good fuel pressure under a load.
So, with that. If you look in the back at the jet pump, look on top of it on the hull an you'll see a port with threads. Can thread your hose to it or buy one of those adapters for soap for a water hose and thread that into it. Start it first, don't open the pressure all the way "just enough to get flow", and turn the water off then shut the ski off
@@goodtimentools619 not sure I was going to ask you if you have any idea. From what I can see in the oil filler neck the check valve ( in a picture ) shows it attached to filler neck have you ran without it attached?
@@richarddedrick1098 I went on partzilla and just found wherer it went. Actually will today or tomorrow i can take the filler neck off and figure out what its for.
I think it was more of a lubricant.... I would use some left over oil from your tank if your pumping any out... if too just get some fresh oil for your seafood and put some around the rubber grommet for easier install
DUDE! SO GOOD! Thanks from Canada.
I appreciate it!!
Once you have reinstalled the new tank. Do you just fill it up with oil and go? Or do you have to bleed the system of air pockets in the oil system?
I am curious about this too
Great video!
Is there a way to replace the tank without taking the motor out
Quick question on the 2000 Sea-Doo bombardier and 951 is there a oil dipstick on this jet ski I cannot find one to save my life I always work on four wheelers I never work on jet skis at all please somebody I need help
U got a motor in there? Got a leak on mine and don't know if I'm going to be able to get out.
No sr. When I did it, the motor was actually out the ski. Not sure if it can be done with the motor in the ski
It can be done just more of a pain in the but
Hey Good Timen Tools, I have a question, I have a 2002 Seadoo Bombardier GTX DI, and when I put it in the water runs like a minute and dies, wait couple of minutes and starts again runs for a minute and dies again, I can find what the problems is.! any Advise I will appreciate.
Well..... These things are a royal pain the the a$$. Im still fighting with chasing issues with this one. In your case, if you can run a remote fuel pressure guage to check if your maintaining good fuel pressure under a load.
@@goodtimentools619 thanks
Hey I just got the same one, where do I hook the hose up to flush it?
So, with that. If you look in the back at the jet pump, look on top of it on the hull an you'll see a port with threads. Can thread your hose to it or buy one of those adapters for soap for a water hose and thread that into it. Start it first, don't open the pressure all the way "just enough to get flow", and turn the water off then shut the ski off
The part u found in the tank is a check valve installed on the oil filler neck I just found the same thing?
ahh...but i wonder why it was inside the tank?
@@goodtimentools619 not sure I was going to ask you if you have any idea. From what I can see in the oil filler neck the check valve ( in a picture ) shows it attached to filler neck have you ran without it attached?
@@richarddedrick1098 I went on partzilla and just found wherer it went. Actually will today or tomorrow i can take the filler neck off and figure out what its for.
@@richarddedrick1098 I had pulled apart the filler neck and dont see where it went. Il roll with it like that for now.
@@goodtimentools619 let me know how you make out I still have not found where it goes. Only by picture
What was the white sealer that you applied around the two tank fittings?
I think it was more of a lubricant.... I would use some left over oil from your tank if your pumping any out... if too just get some fresh oil for your seafood and put some around the rubber grommet for easier install
@@Hueizzy
Thanks for the information!!
Paul
Any videos on oil change/process for seadoo 2cycle?
Its Premix or stock set up?
What kind of oil do you use?
Sorry for the late response, was working on my ole Ladys Tahoe. Its a customers ski and he runs XPS E-Tec full synthetic 2-stroke oil.
Que tipo de aceite lleva??
I couldn't see how you took the bottom off did you just cut the hose off
the big hose from the belly of the motor?
@@goodtimentools619 belly
I got it ,I just pulled the hose off ,thank you
@@ralphzavala8757 my bad. Southern speech. Belly for us is the bottom.