Fantastic build! Did you ever try to build the project with platformio? Would also be nice to see a bit more how this connects to the grblHAL board. And if I may suggest, adding the gerbers, the bom and the p&p file and the hex as release artifacts would be super useful. Great project!
looking good, think making it open source might help you build a larger communbity and support for your work and products. I was looking at the firmware and looks like you added usb cdc support so it can act as a usb host vs using uart ? if so that is great as I wanted to try to run and operate without a PC on my current project
Fantastic build! Did you ever try to build the project with platformio?
Would also be nice to see a bit more how this connects to the grblHAL board.
And if I may suggest, adding the gerbers, the bom and the p&p file and the hex as release artifacts would be super useful.
Great project!
Have you considered partnering up with PCBway? They could produce the board for us and you can get a small kickback too.
looking good, think making it open source might help you build a larger communbity and support for your work and products. I was looking at the firmware and looks like you added usb cdc support so it can act as a usb host vs using uart ? if so that is great as I wanted to try to run and operate without a PC on my current project
No, at this point it works as a USB CDC device. It is for debug purposes - all data traffic between the pendant and controller can be sent to USB too.
Amazing man. Can you make 5 axis camera slider controller using Arduino maga and python(GUI)