How to run BLDC motor with servo tester

[@architnema415]

is there any specific ampere requirement like what is the range we can use for 220kv motor

[@usernotfound3963]

I wired everything according to the video but my motor just goes back and forth just like vibrating tested it like 30 times and no difference please help

[@garyvale8347]

helpful video !!!! I was unsure if I was able to use my 3S 2200 mAh LiPo to test my servos with , because the tester states 4.0v - 6.0v range.....but if I understand correctly , as long as I connect the higher voltage LiPo battery through the ESC, ( and connect the signal wire to the OUTPUT side only ) it's OK...correct?....thanks

[@rexcode9366]

Yes, correct

[@harialingal]

Thanks for your answer. I am new to electronics so not having full knowledge.

[@ManjulaY-i3v]

Price

[@rernajunaedi725]

Klu pke esc 40 a pke mtor nya ukur,n brapa ya gan

[@shivrathore9770]

12volt dc ka kitne Amps ka charger use Kiya h aapne

[@harialingal]

Video me 12V charger ka nameplate dikhaya hai. 12V, 1.2A rating hai charger ka

[@thienvu4503]

the motor just give constant beep, the servo test have no light on. So which part is defect?

[@thecrazerkid2146]

Servo tester

[@emanahmed7105]

perfect it helped me a lot in my graduation project thank you very much, now i need to display the PWM of servo tester in the serial monitor of Arduino can you help me with the code? it seems like i cant with this code:
void setup()
{
Serial.begin(9600);
}
void loop()
{
int Sensor = analogRead (A0);
Serial.println(Sensor);
delay(1000);
}

[@rudyho3790]

Keep simple...use a tx, Rx, ESC, motor,and lipo for power...Much faster and simple🤔

[@goodmorningtraders7815]

WOW 👌👌👌👌👌👏👏👏👏👍👍👍