look on page 17 ( you can lower the amperage ( nine setting ) ( for people who do not have an 100 amps to spar I have a 2023 ford Lighting , I have mine sect at 50 amps on a 60 amp breaker. Robert
If you went to my" follow up" section that is exactly what I did, mine is running at 64 amps. I should have mentioned the 9 position switch in the video, thanks. You can actually derate the FCSP to 12 amps. I am guessing yours is at 48 amps 👍
Thanks for the video, I have a question, I installed my charger it's outdoor. I have a 200A for my house and 100A for the car. the breakers for the car and the main breaker (the 200A) are getting very hot to the point that my main phase from the electrical company melted down. any idea why it happens?. btw I didn't torque the screws, can it be because I didn't torque it?
So many things that could have gone wrong. Did you follow the FCSP instructions, including wire size? Did you follow my advice on the video? I am guessing you did not put a temp probe at the breaker like I did, look at the follow up on the video, it is at the end. I am also guessing you were using the full 80 amps? Torquing is so important and that is why I stressed that so many times in the video.
@@zweare1I saw some blue and brown wires and some small communication wires too..did you have to mess with those? Or did you only have to hook up the #3 copper from the panel?
![[กูเพิ่งซื้อมึงปิดหนี] 20 นาที ผมรีวิวเกมที่แย่ที่สุดในโลก CONCORD](http://i.ytimg.com/vi/XhC-3q3Ii7I/mqdefault.jpg)
look on page 17 ( you can lower the amperage ( nine setting ) ( for people who do not have an 100 amps to spar
I have a 2023 ford Lighting , I have mine sect at 50 amps on a 60 amp breaker.
Robert
If you went to my" follow up" section that is exactly what I did, mine is running at 64 amps. I should have mentioned the 9 position switch in the video, thanks. You can actually derate the FCSP to 12 amps. I am guessing yours is at 48 amps 👍
Thanks for the video, I have a question, I installed my charger it's outdoor. I have a 200A for my house and 100A for the car. the breakers for the car and the main breaker (the 200A) are getting very hot to the point that my main phase from the electrical company melted down. any idea why it happens?. btw I didn't torque the screws, can it be because I didn't torque it?
So many things that could have gone wrong. Did you follow the FCSP instructions, including wire size? Did you follow my advice on the video? I am guessing you did not put a temp probe at the breaker like I did, look at the follow up on the video, it is at the end. I am also guessing you were using the full 80 amps? Torquing is so important and that is why I stressed that so many times in the video.
Not sure if you gave enough information about the wire length and gauge
I used 3.3.3.5 CU and it was 42 feet. I thought for sure I had put that in the video
@@zweare1 where is the best place to buy this and is it copper
Copper is crazy expensive. I ended up buying mine on eBay. Seller: Bobdraper85
Link to the tools you used?
@@zweare1I saw some blue and brown wires and some small communication wires too..did you have to mess with those? Or did you only have to hook up the #3 copper from the panel?