Thanks, We use a few different runners depending of what type & size the cab is , we use a mix of Furnica undermount Runners , Blum undermount, accuride side mount if need a side mount at top mixed in
Thanks 👍🏻 We use a few different runners depending of what type & size the cab is , we use a mix of Furnica undermount Runners , Blum undermount, accuride side mount if need a side mount at top mixed in
Hi mate there’s a few ways depending on the size of peice and the angle , you can use backwards maths off 90 and cut from the other edge leaving the remainder bigger angle on your workpiece or make a 45 degree jig then just add on to the blade the extra degrees to go past 45 where you need 👍🏻
We use a few different runners depending of what type & size the cab is , we use a mix of Furnica undermount Runners , Blum undermount, accuride side mount if need a side mount at top mixed in
What a wicked vid. Skill, beauty and fun 😊
😊👍🏻
Another brill video great to watch all ways amazing results great team 👍👍👍
Thank you 👍🏻
They look a treat under the stairs we'll done to you all and the team have a good day and weekend cheers 🍻 simon
Thank you Simon, you too, have a great weekend 👍🏻👍🏻
Amazing work 😮
Thanks 😊
Nice work. What touch to open drawer runners do you use ?
Thanks, We use a few different runners depending of what type & size the cab is , we use a mix of Furnica undermount Runners , Blum undermount, accuride side mount if need a side mount at top mixed in
Great vid! What runners do you use?
Thanks 👍🏻 We use a few different runners depending of what type & size the cab is , we use a mix of Furnica undermount Runners , Blum undermount, accuride side mount if need a side mount at top mixed in
How do you cut angles on carcass sides over 45°? I’ll usually cut 45° then adjust with a plane but feel this isn’t the best way. Cheers
Hi mate there’s a few ways depending on the size of peice and the angle , you can use backwards maths off 90 and cut from the other edge leaving the remainder bigger angle on your workpiece or make a 45 degree jig then just add on to the blade the extra degrees to go past 45 where you need 👍🏻
What push to open/soft close runners you using?
We use a few different runners depending of what type & size the cab is , we use a mix of Furnica undermount Runners , Blum undermount, accuride side mount if need a side mount at top mixed in
How do you make the joint on the angle pieces? Its that a lamello too?
Hi yes all depending on the angle - the Top angle can have Tenso or clamex - bottom joint can’t so we screw that
Do you always use renner paint
We do mainly now yes we just find it goes on better than other brands we’ve used, for us it’s worth paying that bit extra